Marty Henry
Member

2876 Likes

Page 133 of 192 First ... 3383119120121122123124125126127128129130131132133134135136137138139140141142143144145146147183 ... Last

• Jump to page:

1. 
   Marty Henry liked post by johnd On thread : Notes for New and Newish Hand Loaders from an Old Fudd

   This is good work grandpamac I would like to ask that other experienced reloaders AVOID chiming in and leave you to run the whole process, so that it can be left as a sticky for beginners and...

   Liked On: 31-03-2020, 11:18 AM

2. 
   Marty Henry liked post by timattalon On thread : 22mag vs 17hmr

   I looked at something similar a while back. I was tossing up between the two, ans would up getting a 223. Ammo was not much more, (less if I reload) and I could slow it down or use heavier pills at...

   Liked On: 31-03-2020, 07:36 AM

3. 
   Marty Henry liked post by grandpamac On thread : Notes for New and Newish Hand Loaders from an Old Fudd

   Greetings All, I've noted a couple of new and prospective handloaders on the Forum that are using the lock down to progress their knowledge. Admirable. I thought it might be useful to share how I go...

   Liked On: 30-03-2020, 10:10 AM

4. 
   Marty Henry liked post by HNTMAD On thread : 2020 SHOT STAGS

   You mean they not dropped like these jewels https://uploads.tapatalk-cdn.com/20200329/fc1744c74bcb4427439ed020e38050ca.jpg Sent from my SM-G960F using Tapatalk

   Liked On: 29-03-2020, 03:00 PM

5. 
   Marty Henry liked post by Norway On thread : Blaser 4-20x58 IC

   I'm in quarantine and got bored. The weak of heart should not watch :XD: I have high hopes for this scope, hopefully squeeze the very last out of twilight when I often find the roebucks. ...

   Liked On: 29-03-2020, 11:01 AM

6. 
   Marty Henry liked post by Tahr On thread : Total lock down in 48hours

   Yes, They roar every year, and they are still making them.

   Liked On: 28-03-2020, 08:21 AM

7. 
   Marty Henry liked post by hunterAT On thread : A dream come true

   Actually my flight back home would have been today. But it has been cancelled for obvious reasons so I am sitting in a Fairlie motel and share the burden that you Kiwis bear. And there is plenty of...

   Liked On: 27-03-2020, 06:43 PM

8. 
   Marty Henry liked post by 6mm ackley On thread : What are the best cuts of meat from a possum ?

   The best bits are the pieces that don't have tire marks on them

   Liked On: 27-03-2020, 07:48 AM

9. 
   Marty Henry liked post by 300_BLK On thread : Best hold for ultralight rifle

   Def use two hands...

   Liked On: 14-03-2020, 06:29 PM

10. 
    Marty Henry liked post by kiwijames On thread : Carbon cleanup

    It's going to come back and doesn't affect anything so why would you bother?

    Liked On: 10-03-2020, 08:21 AM

11. 
    Marty Henry liked post by Micky Duck On thread : Howa 223 not shooting well and my quest to fix it

    geeze you guys dont know what a bad trigger is...when I first got my winchester model 70 lightweight...you found a deer,dug a strainerpost hole,rammed in a strainer,tied the rifle to it and then...

    Liked On: 10-03-2020, 07:15 AM

12. 
    Marty Henry liked post by dogmatix On thread : SMLE restoration update.

    Finally got out my proper camera. This shows the wood colours better. I still want to do few more boiled linseed layers on the top front and bottom woods, topped with a Danish oil layer to...

    Liked On: 09-03-2020, 04:55 PM

13. 
    Marty Henry liked post by 7mmsaum On thread : 708 questions

    #stopfuckinshorteningriflebarrels

    Liked On: 09-03-2020, 11:30 AM

14. 
    Marty Henry liked post by akaroa1 On thread : What little pesties did you bowl over today?

    There were 2 hares sitting on my rifle range this morning around the 50m mark. I snuck in and pulled out the rifle at the front of the safe and shot one off hand with a clean middle chest shot. ...

    Liked On: 08-03-2020, 07:19 AM

15. 
    Marty Henry liked post by timattalon On thread : So how far can you usefully shoot a 7.62x39?

    The Howa is a good choice from what I hear. Scott Trails masterpieces are also very good (very light and not cheap) but he has stopped making them for a bit as he is too busy. Zastava made a nice...

    Liked On: 07-03-2020, 11:41 AM

Page 133 of 192 First ... 3383119120121122123124125126127128129130131132133134135136137138139140141142143144145146147183 ... Last

• Jump to page: