MatiriHunter
Member

24 Likes

Page 1 of 2 12 Last

• Jump to page:

1. 
   MatiriHunter liked post by Barry the hunter On thread : Top Quality Hunting Knives

   248082 thats my main knife at the bottom love good knives handmade in Omura Japan by Tanaka San Matsubara blades - my daughter got it for me when she was teaching english there along with the...

   Liked On: 14-04-2024, 07:42 PM

2. 
   MatiriHunter liked post by john worthington On thread : Top Quality Hunting Knives

   you could have rung i have been in the workshop all day finishing this248105

   Liked On: 14-04-2024, 07:42 PM

3. 
   MatiriHunter liked post by Micky Duck On thread : Shooting help

   so the above is rough best guess with figures....and gave it 2" above bore so worst case,eg high scope mounts. as you can see the red line is bullet path,the black line at 0 is what yo usee through...

   Liked On: 03-07-2022, 10:02 PM

4. 
   MatiriHunter liked post by Micky Duck On thread : Shooting help

   you say what????? as I typed out earlier..the scope is 1.2-2" above the bore...if zeroed at 100 yards,it will cross Xhair at about 60-80 be above till it dropps back through at hundy it wont be...

   Liked On: 03-07-2022, 10:02 PM

5. 
   MatiriHunter liked post by HILLBILLYHUNTERS On thread : Shooting help

   So sighted in at 100 , scope x hair 4'' above centre of bore at 30mtrs , you will be well low

   Liked On: 03-07-2022, 10:02 PM

6. 
   MatiriHunter liked post by jakewire On thread : Shooting help

   Thank god it wasn't a 270. Probably would have gone through, circled round, skinned and detusked it then dropped close to hand for reoading. Maybe. If that thud was a thunk, you have a dead...

   Liked On: 03-07-2022, 10:02 PM

7. 
   MatiriHunter liked post by Micky Duck On thread : Shooting help

   we know it was a .308....but what load???? and did you go back and find the pig???

   Liked On: 03-07-2022, 10:02 PM

8. 
   MatiriHunter liked post by JoshC On thread : Shooting help

   I’d put money on you hitting it where you were hoping. Go back for another look. Big pigs can take a bit of putting down with a boiler room shot. Sent from my iPhone using Tapatalk

   Liked On: 03-07-2022, 10:02 PM

9. 
   MatiriHunter liked post by Woody On thread : Shooting help

   I agree with mr duck. One time I shot a large boar with 160grain 2900'/sec mv just behind shoulder. It took off flat out and I found it stone dead a few minutes later nearly 200 yards away. Another...

   Liked On: 03-07-2022, 10:02 PM

10. 
    MatiriHunter liked post by Cigar On thread : Shooting help

    Have you checked the rifle is still sighted in correctly? A heart shot animal can run 100m or so before it drops, so I second MD's suggestion of going back looking for a dead pig (and take the rifle...

    Liked On: 03-07-2022, 10:02 PM

11. 
    MatiriHunter liked post by Micky Duck On thread : Shooting help

    oh and you DO NOT sit down at 30 yards away from a big pig...if it had turned on you,you would have been easy pickings...standing you may have reloaded and hit it at pointblank range..sitting you pig...

    Liked On: 03-07-2022, 10:02 PM

12. 
    MatiriHunter liked post by Micky Duck On thread : Shooting help

    the thud you heard was bullet hitting pig...unless you found it in dirt??? go back and have a look today,pig shouldnt have gone far. you bullet path will be below Xhair buy no more than 1.5...

    Liked On: 03-07-2022, 10:02 PM

13. 
    MatiriHunter liked post by Cigar On thread : Shooting help

    Being a thermal the scope could be quite a bit higher above the bore (though still unlikely to mean a missed shot at 30m)

    Liked On: 03-07-2022, 10:02 PM

14. 
    MatiriHunter liked post by Trout On thread : Shooting help

    Shot my pig a couple of months ago using a 308,18 inch barrel.Hornady 150gr ssts went thru the sholders broad side at about a 100yds.308 zeroed at a 100yds.100lb bore fell over,giving a couple of...

    Liked On: 03-07-2022, 10:02 PM

15. 
    MatiriHunter liked post by Micky Duck On thread : Shooting help

    200795

    Liked On: 03-07-2022, 10:02 PM

Page 1 of 2 12 Last

• Jump to page: