Then think about things like Lee Enfield rifles, each manufacturer of No1MkIII variants used a repeating format of a letter prefix followed by four digit number. Each block of a letter gave you...
Liked On: 08-06-2023, 05:43 PM
If you are still getting actively expanding propellant gasses out of the suppressor, that will create a lot of noise. Think pulling the hose on an air compressor and the release of pressure from the...
Liked On: 07-06-2023, 03:55 PM
Almost look like the 7mm-08 to Tuatahi's .308 - ballistic twins... Have seen comment from overseas that they are considered equals in the wood and the grind and sharpening on each matters more.
Liked On: 06-06-2023, 12:11 AM
Ahhhhhh - selling... I guess people do that huh?
Liked On: 05-06-2023, 01:31 PM
Each do different things, ultrasonic will clean inside and out and get cases completely clean including the thin layer that stops the case tarnishing. Tumbling will remove adhered carbon such as...
Liked On: 04-06-2023, 09:05 PM
Considering it's considered suitable for a room of stout construction, it would be interesting to see if they would approve of a dual layer of 18mm ply with a section of the compliant 65x65x5mm...
Liked On: 04-06-2023, 08:02 PM
I saw the title for the thread, and thought to myself even the 6.5 crud guys themselves are trying to upsize their choices now haha If you don't have a chrono, you can confirm by measuring out an...
Liked On: 02-06-2023, 04:53 PM
Ahhhhhh - selling... I guess people do that huh?
Liked On: 02-06-2023, 02:01 AM
"Overflow Safe"... Is that a thing? Sounds like one of those nature hates a vacuum situations to me!
Liked On: 02-06-2023, 01:35 AM
Ahhhhhh - selling... I guess people do that huh?
Liked On: 01-06-2023, 11:39 PM
Check out the forum sponser - he's posted on here somewhere about one in the last few weeks. I was meant to get back to him with a few questions for commercial use but I got busy and am slack haha. ...
Liked On: 31-05-2023, 08:10 PM
Hows it look on the handle after a serious amount of work? I had one similar to this design with the front bottom of the eye hole is cut away, and it was a bugger for working loose on the haft. All...
Liked On: 31-05-2023, 12:15 PM
Not unusual, the engine is out of the Nissan light truck line so built a lot heavier than automotive light vehicle engines. It runs a lot lighter loaded than the equivalent car engine, with heavier...
Liked On: 29-05-2023, 12:51 PM
The earlier mounts were better, I put the original 'tired' ones back in for the time it took to build a set that won't break. The other three failed at the adhesion of the rubber to the metal...
Liked On: 29-05-2023, 11:12 AM
Not unusual, the engine is out of the Nissan light truck line so built a lot heavier than automotive light vehicle engines. It runs a lot lighter loaded than the equivalent car engine, with heavier...
Liked On: 29-05-2023, 10:57 AM