Heya Pengy I wouldn't be running any 4x4 tyre on anything less then 34psi,a lot of tyres are built differently and some can really give the shoulders a hard time if you run them to low which can cost...
Liked On: 22-04-2015, 09:32 AM
6 goats , all billies , 4 of them very big , at 177-211 yds , out of a mob of 9 , with the Hornet , all done by single loading the rds in , as the reloads are TOO long for the magazine , its about...
Liked On: 21-04-2015, 11:37 PM
I did the out of warranty replacement through Garmin, Easy as, got a referb 62s for $126nz Hamish
Liked On: 15-04-2015, 06:24 PM
Dont hold ya breath Pengy, I'll do it ....lmao...
Liked On: 14-04-2015, 11:39 PM
Tama iti is holding it hostage for some imagined grievance it caused, you might be able to trade it for a New Zealand flag though...................
Liked On: 14-04-2015, 10:18 PM
Show people are mostly fuckwits and have no empathy for their dogs, to many of them the dog is a commodity that lives in a cage until ring time and they need other people to tell them how wonderful...
Liked On: 14-04-2015, 10:01 PM
Pays to play nice or Kelly in admin jumps up and down a bit. http://images.tapatalk-cdn.com/15/04/13/f17db6f0c0c718c9d7e34a083133efa8.jpg
Liked On: 14-04-2015, 09:13 PM
Well if you shot them recently I'm sure the quail are two hens a bit slow to get off the nest if you went two for two :ORLY: The geese is a little harder to separate from that photo but looking at...
Liked On: 14-04-2015, 04:24 PM
Fk that shit. Only in the office for a couple days then off hunting again :thumbsup:
Liked On: 13-04-2015, 01:53 PM
Sounds like you could start up a tv series :O_O:
Liked On: 13-04-2015, 01:13 PM
I didn't go to the sale. Ended up saving 100%.
Liked On: 13-04-2015, 10:58 AM
I bet you say that to all the girls...
Liked On: 13-04-2015, 10:48 AM
How's it going I was told I should post a bit of write up so here goes hope it makes sense. The first is of my first pig I shot stalking with no dogs I was hunting up Canterbury I had not long...
Liked On: 13-04-2015, 10:47 AM
As a stop gap measure I use a bit of fuel hose and cut it right length and just push that over the thread.
Liked On: 13-04-2015, 10:46 AM
I suspect it was his. Says something about 270 users [emoji38] Sent from my iPhone using Tapatalk
Liked On: 13-04-2015, 10:41 AM