To save modifying an existing powder on-screen each time you could consider updating the powder data file with an extra line for this powder and additional lines for any new powders you may care to...
Liked On: 18-01-2017, 11:04 AM
Further to the previous post and some more info specifically for Feebz' Forbes in case he is interested, putting his results into QuickLoad along with the other powders being mentioned....
Liked On: 15-01-2017, 07:28 PM
Further to the previous post and some more info specifically for Feebz' Forbes in case he is interested, putting his results into QuickLoad along with the other powders being mentioned....
Liked On: 15-01-2017, 07:14 PM
I would suggest that if intending to load the 162gr for 60kPSI peak or over - as seems to be the practice in the endless quest to equal 7mmRM performance - then 2213sc may be the limit for burn rate...
Liked On: 15-01-2017, 09:17 AM
When I was looking to buy my first centrefire, and knowing nothing about hunting, I figured it was best to use the “Wisdom of Crowds” to decide what I should purchase. To this end I spent months...
Liked On: 03-01-2017, 05:55 PM
I haven't read the article but I can see the Creedmoor rating well if recoil was a heavily weighted consideration. I view the smaller 6.5s as sitting at a sweet spot for effectiveness on medium...
Liked On: 03-01-2017, 03:49 PM
I haven't read the article but I can see the Creedmoor rating well if recoil was a heavily weighted consideration. I view the smaller 6.5s as sitting at a sweet spot for effectiveness on medium...
Liked On: 03-01-2017, 11:53 AM
Friwi makes a good point earlier, one that has been aired in other threads, but is worth repeating because few give it the consideration it deserves: if precision dramatically improves when the felt...
Liked On: 14-12-2016, 08:27 PM
Aqueous ammonia, 29%, worked through with barrel solvents using a nylon brush so I guess it forms an emulsion. I don't leave the mix in the barrel for very long, but then have never needed to as it...
Liked On: 14-12-2016, 06:13 AM
Partitions aren't known for stellar accuracy. I'm a strong believer in bullet-barrel match. Maybe another powder will give better results, maybe your rifle just doesn't like those particular...
Liked On: 11-12-2016, 09:24 PM
Partitions aren't known for stellar accuracy. I'm a strong believer in bullet-barrel match. Maybe another powder will give better results, maybe your rifle just doesn't like those particular...
Liked On: 11-12-2016, 06:35 PM
Friwi makes a good point earlier, one that has been aired in other threads, but is worth repeating because few give it the consideration it deserves: if precision dramatically improves when the felt...
Liked On: 09-12-2016, 10:48 AM
If reloading then you are able to consider any case with perhaps a preference for readily available quality brass and dies, and all common cases will deliver a 130gr or 140gr ELD or Berger at above...
Liked On: 07-12-2016, 05:59 PM
Hi Quentin, I ran your previous load through QuickLOAD while using the QuickLOAD 6.5x55 specs, so that is the 140AMAX with 44.7gr of 2209 from a 22.5" barrel, and the predicted velocity is very close...
Liked On: 17-11-2016, 02:57 PM
I have an very well used early 90's Vari-X III where the elevation & windage adjustments developed a lot of backlash and the two adjustments interacted on account of a failing single opposing spring....
Liked On: 15-11-2016, 07:07 AM