Just turned 2 stage actuator over and trying as single stage trigger, a small vee for the spring and a slight radius. Feels nicer than when being 2 stage and the good thing I can always just turn it...
Liked On: 11-01-2023, 03:11 PM
Apparently there is a gunsmith in the states who has modified the NS522 trigger to adjust the sear position by fitting a small screw in position shown below that adjusts trigger position against the...
Liked On: 10-01-2023, 10:20 AM
Good one Chris glad you had a go and that you have got the same result I’m getting much smoother feel on mine for sure, I put a trigger over travel screw in aswell which helps too. At least you can...
Liked On: 09-01-2023, 10:55 PM
Just turned 2 stage actuator over and trying as single stage trigger, a small vee for the spring and a slight radius. Feels nicer than when being 2 stage and the good thing I can always just turn it...
Liked On: 09-01-2023, 10:54 PM
Just turned 2 stage actuator over and trying as single stage trigger, a small vee for the spring and a slight radius. Feels nicer than when being 2 stage and the good thing I can always just turn it...
Liked On: 08-01-2023, 02:41 PM
I just Put in a screw where front sight was and use that to have the silencer bayonet fitted push on and turn, no screw threading needed just a slot in silencer.
Liked On: 26-07-2022, 02:07 PM
Had a couple of printed suppressors done and worked very good still got files. Anyone want SolidWorks design work doing just shout as I have own licensed program.
Liked On: 24-07-2022, 03:14 PM
Had a couple of printed suppressors done and worked very good still got files. Anyone want SolidWorks design work doing just shout as I have own licensed program.
Liked On: 24-07-2022, 10:21 AM
Had a couple of printed suppressors done and worked very good still got files. Anyone want SolidWorks design work doing just shout as I have own licensed program.
Liked On: 23-07-2022, 10:30 PM
Had a couple of printed suppressors done and worked very good still got files. Anyone want SolidWorks design work doing just shout as I have own licensed program.
Liked On: 23-07-2022, 10:19 PM
Had a couple of printed suppressors done and worked very good still got files. Anyone want SolidWorks design work doing just shout as I have own licensed program.
Liked On: 23-07-2022, 10:15 PM
Ready to get a few rabbits again with old Baikal 12g with concentric fitted unused Anshutz 1410 barrel Firing pin can be changed from concentric for 12g to offset pin for .22lr $100 for shotgun $40...
Liked On: 12-05-2022, 06:40 PM
Cheer’s mate looking forward to a bit of pest control, not the obvious gun for the job but suits me.
Liked On: 11-05-2022, 09:45 AM
Ready to get a few rabbits again with old Baikal 12g with concentric fitted unused Anshutz 1410 barrel Firing pin can be changed from concentric for 12g to offset pin for .22lr $100 for shotgun $40...
Liked On: 10-05-2022, 10:29 PM
Ready to get a few rabbits again with old Baikal 12g with concentric fitted unused Anshutz 1410 barrel Firing pin can be changed from concentric for 12g to offset pin for .22lr $100 for shotgun $40...
Liked On: 09-05-2022, 05:44 PM