SikaHuntaa The ball bearing in the hole idea didn't work on my cap as the existing hole is nowhere near '0'. I used a 1.5mm drill bit to drill the hole and then cut off the shank end of the...
Liked On: 26-01-2023, 08:34 AM
SikaHuntaa The ball bearing in the hole idea didn't work on my cap as the existing hole is nowhere near '0'. I used a 1.5mm drill bit to drill the hole and then cut off the shank end of the...
Liked On: 25-01-2023, 11:02 PM
SikaHuntaa The ball bearing in the hole idea didn't work on my cap as the existing hole is nowhere near '0'. I used a 1.5mm drill bit to drill the hole and then cut off the shank end of the...
Liked On: 25-01-2023, 10:36 PM
Also be aware that you will get apparent pressure signs with any load if the rifle chamber has oil/lube in it or on the brass cases. Make sure you mop out the rifle barrel and chamber when you take...
Liked On: 18-01-2023, 06:23 AM
Awesome! Glad you sorted it!
Liked On: 15-01-2023, 07:07 PM
Yep can't go wrong with a tikka.
Liked On: 11-01-2023, 01:24 PM
Yep can't go wrong with a tikka.
Liked On: 11-01-2023, 11:25 AM
I started another load for my 18" 6.5PRC. 147gr eld-M. The 143 eld-X are too hard to get now. I tried two powders to start ( 2225 and RL26) and two primers with the 2225. Looks like it'll shoot...
Liked On: 29-12-2022, 11:12 AM
I started another load for my 18" 6.5PRC. 147gr eld-M. The 143 eld-X are too hard to get now. I tried two powders to start ( 2225 and RL26) and two primers with the 2225. Looks like it'll shoot...
Liked On: 28-12-2022, 07:46 PM
Standard Dpt w/SS baffle on my 18" 6.5prc. It has handled 700 rounds so far.
Liked On: 27-12-2022, 12:04 PM
Standard Dpt w/SS baffle on my 18" 6.5prc. It has handled 700 rounds so far.
Liked On: 26-12-2022, 03:49 PM
Standard Dpt w/SS baffle on my 18" 6.5prc. It has handled 700 rounds so far.
Liked On: 26-12-2022, 11:55 AM
This ^ The rear bush is probably the issue. Take it off the suppressor and shoot some test groups. I have experienced the rear bush issues with two rifles/suppressors now. I think that the Bush...
Liked On: 10-12-2022, 10:40 AM
Very cool. I've recently bought a lathe and have been slowly tooling up to play around with basic firearm machining. I've been practicing threading and crowning barrel stubs. I'm after some...
Liked On: 13-11-2022, 07:47 PM
If you read that linked article properly you will see that the Shooter has custom reamed dies that act like a bushing die, which sizes the neck o.d. spot on. He also lubes the inside case neck just...
Liked On: 01-10-2022, 09:35 PM