Hi winaa, Assuming you're after a charger for NiMH batteries, I use and highly rate the Maha MH-C9000 Pro charger. It's probably the best NiMH only charger out there and can charge 1-4 cells,...
Liked On: 13-04-2021, 01:23 PM
Ive tried a couple with zero experience under my belt, and as you would expect the results are terrible. Completely ruined this awesome piebald(?) rabbit skin, but at least it is an object of comedy....
Liked On: 14-03-2021, 05:32 PM
Durex
Liked On: 13-03-2021, 09:10 PM
I do the same with cheap clay shooting rounds, pick the star crimp open, pour out the shot, melt it and cast 1oz slugs with the Lee mold then poke them back in and roll crimp them. Haven't tried...
Liked On: 10-10-2020, 08:25 PM
Yeah used the gun club ammo too. They will go right through a goats backbone at 60 yds. Got a sxs shortened by 6in and express sights. Poor mans double rifle.
Liked On: 10-10-2020, 08:25 PM
I cast my own Lyman 525gr slugs, reasonably accurate too, ive tinkered with cutting the petals back and off, even used ballistic product cushions wads, a load of fun! Smallfoot if your really going...
Liked On: 10-10-2020, 07:16 PM
I used a lee mold they have a bar across the inside of them. Just carefully cut the top off a shell and pour the shot out and poke the slug in the cup. If you dont cut too much off you can roll...
Liked On: 10-10-2020, 05:58 PM
I know of someone who casts the lyman and lee mould ones. I have a mould for the Lee one if that helps. It's a little rusted, and a little rough, you can have it if you do any casting.
Liked On: 10-10-2020, 05:30 PM
Ahhhhhhhhhhhhhhhh. Your image tickled the little gray cells and I went searching and found i had a 100 pack of Lyman 520 gr 12gauge slugs. Just like the right hand ones in your image. AS I...
Liked On: 10-10-2020, 04:44 PM
These are fun on goats, go off like a crack from a rifle, good out to 100 metres...haven't made any for a while, usually make the slugs during the winter in the wood burner. 151055
Liked On: 10-10-2020, 04:44 PM
they were for sale on trademe pretty much anytime Ive looked for last few years....you CAN get round ball sinker of correct diameter and drop that inside you wad too...not hard to work out correct...
Liked On: 10-10-2020, 04:33 PM
Go find the cheapest pair of jandels you can find and a craft knife.....
Liked On: 24-05-2020, 09:56 PM
So one of the things I loved about the lock down was I had time to actually sit down and get a few ideas that had being floating around in my head for awhile started. As some of you may recall I...
Liked On: 24-05-2020, 09:37 PM
Set it for impacts at 100 yards while developing a load then run it in an app like strelok and work out your MPBR and the zero that corresponds with it. This will depend on what velocity you end up...
Liked On: 24-05-2020, 09:22 PM
Banned... Sent from my F5321 using Tapatalk
Liked On: 31-07-2019, 10:10 AM