SPEARONZ
Member

451 Likes

Page 14 of 31 First 12345678910111213141516171819202122232425262728 ... Last

• Jump to page:

1. 
   GSP HUNTER liked post by SPEARONZ On thread : 7mm08 appreciation thread

   Just aim for lungs on smaller deer. I’ve found the younger animals can take a few steps while full body reds have all been bang flops when targeting high shoulders. 162s leave an impressive blood...

   Liked On: 22-05-2024, 07:51 AM

2. 
   JimmyJames liked post by SPEARONZ On thread : Backlanz vs MTN Gear bipods

   The back country is perfectly adequate and has the same adjustability as an atlas. It does have a very wide stance which is good for stability but will limit how high you can raise the rifle. I’ve...

   Liked On: 14-05-2024, 09:57 AM

3. 
   Fisherman liked post by SPEARONZ On thread : Hey Gimp is this you hiding out

   It’s more about not smashing my suppressor with the magnum

   Liked On: 10-05-2024, 06:39 PM

4. 
   Fisherman liked post by SPEARONZ On thread : Hey Gimp is this you hiding out

   10rnds to in a thin barrel is asking a lot. Could timelapse 3 x groups I’ll just have to break position in between.

   Liked On: 10-05-2024, 06:20 PM

5. 
   Philipo liked post by SPEARONZ On thread : Best factory ammo I've ever seen, chur chur

   Their 7/08 is the most accurate factory ammo I've used. Shoots real slow but. Been reloading the factory brass and haven't culled a single case after 4 relatively stiff loads.

   Liked On: 06-05-2024, 10:32 PM

6. 
   Scott29er liked post by SPEARONZ On thread : Best factory ammo I've ever seen, chur chur

   Their 7/08 is the most accurate factory ammo I've used. Shoots real slow but. Been reloading the factory brass and haven't culled a single case after 4 relatively stiff loads.

   Liked On: 06-05-2024, 10:15 PM

7. 
   dannyb liked post by SPEARONZ On thread : Rangefinder binos

   Yes Yes No If you choose the TBR setting it will display the LOS first followed by the TBR a second or two later Imo unless the binos can measure environmentals there’s no point having in...

   Liked On: 02-05-2024, 09:41 PM

8. 
   samohtxotom liked post by SPEARONZ On thread : Kestrel elite and accuracy first

   Please select all the images containing traffic lights

   Liked On: 27-04-2024, 02:45 PM

9. 
   tibo liked post by SPEARONZ On thread : Kestrel elite and accuracy first

   Please select all the images containing traffic lights

   Liked On: 27-04-2024, 09:52 AM

10. 
    199p liked post by SPEARONZ On thread : 7prc new buid

    I think I’ll probably end up putting a short barrel 7mm together to give it a go

    Liked On: 13-04-2024, 09:38 PM

11. 
    chainsaw liked post by SPEARONZ On thread : Is the new 7mm PRC a lemon ?

    The best cartridge appears to be anything that likes to burn RL26… Seems all bold claims about performance these days relies more on the powder than cartridge design. I hope ADI are developing...

    Liked On: 09-04-2024, 01:03 PM

12. 
    Goose liked post by SPEARONZ On thread : Thoughts on the 300 PRC

    Bagheera Just run a suppressor full time, 24inches ain’t too bad for a snap shot. I’m running an optima45 and it is handling the muzzle pressure sweet as and it weighs bugger all. 215bergers have...

    Liked On: 26-03-2024, 10:17 PM

13. 
    Bagheera liked post by SPEARONZ On thread : Thoughts on the 300 PRC

    Bagheera Just run a suppressor full time, 24inches ain’t too bad for a snap shot. I’m running an optima45 and it is handling the muzzle pressure sweet as and it weighs bugger all. 215bergers have...

    Liked On: 26-03-2024, 10:09 PM

14. 
    stagstalker liked post by SPEARONZ On thread : Realistic range of 16" 708?

    I’d take a slower 162eldm over a slightly faster 150 eldx any day. Theory is cool and all that but eldx at those speeds often only works in close.

    Liked On: 26-03-2024, 02:16 PM

15. 
    caberslash liked post by SPEARONZ On thread : Realistic range of 16" 708?

    I’d take a slower 162eldm over a slightly faster 150 eldx any day. Theory is cool and all that but eldx at those speeds often only works in close.

    Liked On: 26-03-2024, 09:19 AM

Page 14 of 31 First 12345678910111213141516171819202122232425262728 ... Last

• Jump to page: