Some advice: If buying new, much reloading stuff can be imported via amazon (as it is currently not regulated), at far lower prices than the domestic resellers trying to rip us off...
Liked On: 19-06-2024, 11:45 AM
thread relief cuts are common and good practice in any engineering application requiring a shoulder to index against.
Liked On: 18-06-2024, 04:05 PM
*corrupt
Liked On: 18-06-2024, 02:04 PM
thread relief cuts are common and good practice in any engineering application requiring a shoulder to index against.
Liked On: 18-06-2024, 09:04 AM
thread relief cuts are common and good practice in any engineering application requiring a shoulder to index against.
Liked On: 18-06-2024, 08:49 AM
advertisment.
Liked On: 18-06-2024, 08:45 AM
*corrupt
Liked On: 17-06-2024, 07:03 PM
You'll need more than your other kidney to do hand loads. Consider primer, powder, projectile and brass prices, and compare with your favorite factory ammo. And then the equipment, on top of that....
Liked On: 16-06-2024, 02:39 AM
You'll need more than your other kidney to do hand loads. Consider primer, powder, projectile and brass prices, and compare with your favorite factory ammo. And then the equipment, on top of that....
Liked On: 15-06-2024, 01:38 PM
You'll need more than your other kidney to do hand loads. Consider primer, powder, projectile and brass prices, and compare with your favorite factory ammo. And then the equipment, on top of that....
Liked On: 15-06-2024, 01:25 PM
If you need a muzzle break on a 6prc you should stick to rimfire
Liked On: 14-06-2024, 08:19 AM
Waaaaayyyyyyyyyy too many tourists and hikers everywhere!
Liked On: 11-06-2024, 08:04 PM
Common sense prevails against ideologues... Very nice...
Liked On: 05-06-2024, 08:35 PM
I think with this freeze dried stuff salt is the least of your problems. Personally far prefer real meals over the backcountry *yuck* But do need to add a ton of salt to suit my taste. As...
Liked On: 05-06-2024, 04:34 PM
Common sense prevails against ideologues... Very nice...
Liked On: 31-05-2024, 10:29 PM