The extra low in 30mm works fine with the 30mm VX5 2-10x42 on a Tikka T3x so would work okay on the 30mm VX3i 4.5-14x42 and give you an even lower cheek weld.
Liked On: 12-02-2020, 06:04 PM
I thought it went into receivership? Sent from my SM-G975F using Tapatalk
Liked On: 12-02-2020, 08:17 AM
Wow, please tell me this isn'ton doc land.
Liked On: 01-02-2020, 11:17 PM
I can understand where you're coming from, OP. Your stance is very 'tweed coat and top hat'; one which goes against the grain of today's thinking. Perhaps you could take a time machine back to the...
Liked On: 01-02-2020, 08:18 PM
The horse has bolted........ My only concern is that the Waro boys are using them now to smack those big smart stags down here....
Liked On: 01-02-2020, 08:16 PM
If you want to fill your freezer without poaching or having a bomb up that leaves a lot of rotting meat, then I don't think there's anything wrong with it. It's where you use thermals to be a...
Liked On: 01-02-2020, 08:14 PM
Turn that front ring around and push the scope forward Sent from my iPhone using Tapatalk
Liked On: 01-02-2020, 11:21 AM
For me it’s a bridge too far and tips the balance too much in the hunter’s favour. I have always been of the opinion that the hours of darkness give our prey a little respite, which is now being...
Liked On: 30-01-2020, 01:46 AM
They are amazingly good boots but I'm not new to hunting and can't be considered young except by macca 49
Liked On: 24-01-2020, 11:42 PM
http://mpicustomstocks.com/ https://www.facebook.com/MPIStocks/
Liked On: 24-01-2020, 12:33 PM
That will depend on the projectile used. But in the case of my 7mm-08 and 162gr ELD-M I'm restricted by the magazine length, it's a long way off the lands. I'm away from home so I can't measure it....
Liked On: 23-01-2020, 10:14 PM
Locktite! I don't know how spell check came up with licktite
Liked On: 23-01-2020, 12:21 AM
Haha, my setup looks pretty much the same as it was in previous post (page 6), only I decided to lengthen the foregrip a bit. It has gotten a little bit lighter though, Jacinda brought my DPT and I...
Liked On: 23-01-2020, 12:19 AM
heavy doesn't make it accurate tho heavy just makes it easier to shoot i definitely find my kimber harder to shoot than my sako 75 piggy but its no less accurate
Liked On: 19-01-2020, 10:17 AM
Stocky thanks mate yeah will do, have had a good look around and found that there has been two revisions of the CIP standard reamer, Rev B has a freebore measurement of .3645", whereas the original...
Liked On: 18-01-2020, 10:38 PM