Tikka T3 is pretty hard to beat.
Liked On: 07-06-2021, 10:57 AM
Tikka T3 is pretty hard to beat.
Liked On: 07-06-2021, 10:00 AM
Tikka T3 is pretty hard to beat.
Liked On: 07-06-2021, 03:59 AM
Tikka T3 is pretty hard to beat.
Liked On: 06-06-2021, 11:26 PM
Tikka T3 is pretty hard to beat.
Liked On: 06-06-2021, 06:43 PM
Tikka T3 is pretty hard to beat.
Liked On: 06-06-2021, 05:42 PM
Tikka T3 is pretty hard to beat.
Liked On: 06-06-2021, 05:22 PM
+1 for Steve Gooding. We hired an outboard motor and life jackets off him. Motor was excellent. Started first pull every time. I have been to Abrahams Bay and Little Glory. I preferred Abrahams but...
Liked On: 05-06-2021, 08:48 PM
Nicely done!!
Liked On: 05-06-2021, 06:34 PM
+1 for Steve Gooding. We hired an outboard motor and life jackets off him. Motor was excellent. Started first pull every time. I have been to Abrahams Bay and Little Glory. I preferred Abrahams but...
Liked On: 05-06-2021, 04:34 PM
Nice finish. You could add some black pigment to the initial “gel coat” you put in mold. That way you wouldn’t need to paint it or if you did paint the scratches wouldn’t show up as much.
Liked On: 04-06-2021, 10:12 PM
Nice finish. You could add some black pigment to the initial “gel coat” you put in mold. That way you wouldn’t need to paint it or if you did paint the scratches wouldn’t show up as much.
Liked On: 04-06-2021, 07:13 PM
Nice finish. You could add some black pigment to the initial “gel coat” you put in mold. That way you wouldn’t need to paint it or if you did paint the scratches wouldn’t show up as much.
Liked On: 04-06-2021, 11:25 AM
Tuidog I used maguires release wax, I think it is a car wax.
Liked On: 03-06-2021, 04:59 PM
I use to make the action inlet mold the same way, but after a few uses the silicon ripped apart. I then swapped to useing silicon sealant you get in the tubes. It is a bit of a bugger to work with...
Liked On: 03-06-2021, 08:56 AM