If you take trailer to Briford, get Brian to weld plate & supply plunger coupling. No need for u bolts. Sent from my SM-S906E using Tapatalk
Liked On: 27-03-2023, 03:25 PM
Roberlo Robliner is far better, harder finish, more durable, and tintable as well. Its also cheaper
Liked On: 17-03-2023, 07:28 AM
hammerite......its good stuff and harder than hobs of hell.... its a 4x4 its not a show pony...you will likely keep it till its not worth bugger all so doing a hard wearing lasting paintjob by hand...
Liked On: 16-03-2023, 07:46 PM
I use these regularly. I now always use a filter funnel to fill the quad or bike, as the inner paint lining is now flaking off. A point to note: fuel kept in these (steel) containers will last...
Liked On: 15-03-2023, 09:12 PM
If rusty either mechanical cleaning or acid removal paste applied. If washing out, petrol is fine, tip out and let the residue evaporate. Don't overthink it...
Liked On: 15-03-2023, 05:58 PM
Think you might be able to get a new seal at Bunnings.
Liked On: 15-03-2023, 01:47 PM
Well, to be fair shooting and killing two people, wounding another and then lighting bush on fire to try and flush out the fourth doesn't seem like something that a rational minded group of people...
Liked On: 17-12-2022, 04:23 PM
Any of the Lyman reloading manuals will have load data for this bullet, the beauty with cast in a 30/30 is that you can use the jacketed data starting loads just work the load up as normal look...
Liked On: 18-09-2022, 07:54 PM
Tell the ol man that his barrel will last forever shooting cast bullets.
Liked On: 18-09-2022, 07:07 PM
205590205591 I have attacked the use of a lever action from a different angle using it mainly for plinking and Hares and Wallabies at close range, and so have used 110 grain rem bulk pack SP,s or...
Liked On: 09-09-2022, 04:45 PM
Yes there will be a bit more bullet jump but the blunt projectiles are pretty tolerant and usually shoot well seated away from the rifling. Crimp variation would be a bigger factor. Even with the Lee...
Liked On: 08-09-2022, 07:22 PM
I have a marlin 336 Texan. I handload with 29 grains of ADI 2206h and 170 gr Sierra flat points. Cheap to load. Sighted for 50m and groups 1inch at 50m. 205552 suits the bush really.
Liked On: 08-09-2022, 02:20 PM
Full length sizing is recommended for lever actions, you don't have the camming action of a bolt-action to push slightly tight cases into the chamber.
Liked On: 08-09-2022, 01:25 PM
Greetings All, Today was a crappy day here in HB, a good day to potter about in the shed. As previously reported I was given an old No1 Lee Enfield a few weeks back. As you can see it's a bit rough...
Liked On: 09-08-2022, 03:47 PM
Why would my tumbled brass be wet? Oh your one of those ss pins wet tumble guys huh. :D
Liked On: 13-07-2022, 06:55 PM