Tikka7mm08
Member

1716 Likes

Page 31 of 115 First ... 171819202122232425262728293031323334353637383940414243444581 ... Last

• Jump to page:

1. 
   Tikka7mm08 liked post by Shearer On thread : Stewart Island footwear, what do you use?

   My usual hunting boots. There is nothing "special" about the island. It can be wet and muddy and sandy and rocky. Like a lot of other places.

   Liked On: 22-04-2021, 12:24 AM

2. 
   Tikka7mm08 liked post by 223nut On thread : Stewart Island footwear, what do you use?

   I just use a 'normal' tramping boot have tried sneakers and find they are a bit cold after a few hours of wet feet. Yes the boots are a bit loud but I'm not a bush ninja and find that leaves go...

   Liked On: 22-04-2021, 12:24 AM

3. 
   Tikka7mm08 liked post by Tahr On thread : 6.5 prc loads

   outdoorlad 270 wsm, 117 grns, 3450 fps. They are devastating on deer. And accurate. I use R26, and I expect that this performance would be within a hairs breadth of the 6.5PRC. In hole (the...

   Liked On: 21-04-2021, 11:30 PM

4. 
   Tikka7mm08 liked post by anim001 On thread : Introduction

   Hi all. I'm Canterbury born and bred and have been watching the forums for a while now - thought I'd finally join. I go after mostly small game at the moment with a ruger 10 /22. Looking to get good...

   Liked On: 21-04-2021, 11:43 AM

5. 
   Tikka7mm08 liked post by Tahr On thread : True Story...

   The stags started to get into it last night and several were really going off. I was sitting down giving the odd roar thinking something might appear and happened to glance over to my left and...

   Liked On: 17-04-2021, 01:20 PM

6. 
   Tikka7mm08 liked post by Pushover On thread : 25-06 why hasn't it achieved fame and success in New Zealand?

   After 20 pages I've forgotten if I chipped in or not. Old age. :thumbsup:

   Liked On: 16-04-2021, 06:27 PM

7. 
   Tikka7mm08 liked post by chainsaw On thread : 168gr Nosler BT

   I run 168 NBTs in my 18in bbl 308. Struggled to find independent validated BC, so looking at Litz's data on other NBTs figured that a 5% reduction from Nosler's BC of 0.49 by 5% should be a good...

   Liked On: 15-04-2021, 11:42 PM

8. 
   Tikka7mm08 liked post by Pauli On thread : EZESHARP Blade Sharpener - a quick review

   Here are my initial thoughts about the EzeSharp Blade Sharpener I purchased recently from www.kentmaster.nz. Price and delivery time were good. Initial set-up was relatively simple after viewing a...

   Liked On: 14-04-2021, 09:08 AM

9. 
   Tikka7mm08 liked post by shift14 On thread : Shotgun Restoration ???

   Regards the shotgun I posted pictures of your comments are all very true. In its original state it was worth zero, the barrels had separated from the ribs and it was useless. However I was prepared...

   Liked On: 12-04-2021, 08:40 PM

10. 
    Tikka7mm08 liked post by MSL On thread : Shotgun Restoration ???

    Money well spent Sent from my iPhone using Tapatalk

    Liked On: 12-04-2021, 08:40 PM

11. 
    Tikka7mm08 liked post by shift14 On thread : Shotgun Restoration ???

    Nelson Collie, Status Guns , Invercargill, tidied up Dads side by side for me. I got onto a guy with a replicator who copied the stock. I got the walnut from a fella in Nelson. The original was...

    Liked On: 12-04-2021, 08:39 PM

12. 
    Tikka7mm08 liked post by Gerardo On thread : So if I start reloading

    A good breathing technique helps for when you think you have your loads sorted... and you don't. Well, I need it anyway. Woosaa Sent from my SM-G975F using Tapatalk

    Liked On: 12-04-2021, 03:33 PM

13. 
    Tikka7mm08 liked post by Hunty1 On thread : Buffalo Mountain Gear?

    It's good stuff, bit different to traditional layering system. I have both the mountain jacket and fell jacket. Never use the mountain jacket as it's too hot. Fell jacket gets alot of use...

    Liked On: 12-04-2021, 01:45 PM

14. 
    Tikka7mm08 liked post by Magnetite On thread : Soot On Case Bodies

    Looks like I forgot to mention the most important part, the suppressor. Thanks for the help.

    Liked On: 12-04-2021, 11:14 AM

15. 
    Tikka7mm08 liked post by rambo-6mmrem On thread : So if I start reloading

    Imo You need Medium-good quality tools from the get go Some lee tools are fine however most of what you get in the “everything you need” kits is shit and you will spend more money buying...

    Liked On: 12-04-2021, 10:16 AM

Page 31 of 115 First ... 171819202122232425262728293031323334353637383940414243444581 ... Last

• Jump to page: