Walker
Member

218 Likes

Page 9 of 15 First 123456789101112131415 Last

• Jump to page:

1. 
   rossi.45 liked post by Walker On thread : Light Varmint/Target Rifle ideas

   Had a Sako A1 heavy barrel 243 that was a tack hammer 75 amax took rabbits at 500m no worries. Shot it in nra comps BUT down side was barrel life, the 243 eats throats so only expect 1500 rds from it...

   Liked On: 14-12-2018, 08:15 AM

2. 
   systolic liked post by Walker On thread : .44 Mag Crimping

   You need to seat with the case level with the top edge of the groove then it will crimp properly But as its a single shot you don't need to crimp and will get better brass life.

   Liked On: 04-11-2018, 08:13 PM

3. 
   Nugget connaisseur liked post by Walker On thread : Gisborne pistol club

   it's still a case of two faced council, allowing land to be sub devided with full knowledge the clubwas there.

   Liked On: 04-11-2018, 05:00 PM

4. 
   chainsaw liked post by Walker On thread : Eugenie Sage

   Maybe it's time to go back to first past the post, with the rate this lot are giving away money on wims and bribes we could not meet our loan obligations and there are no more jewels to sell!

   Liked On: 05-10-2018, 09:40 AM

5. 
   tetawa liked post by Walker On thread : Eugenie Sage

   Maybe it's time to go back to first past the post, with the rate this lot are giving away money on wims and bribes we could not meet our loan obligations and there are no more jewels to sell!

   Liked On: 05-10-2018, 07:48 AM

6. 
   veitnamcam liked post by Walker On thread : Eugenie Sage

   Maybe it's time to go back to first past the post, with the rate this lot are giving away money on wims and bribes we could not meet our loan obligations and there are no more jewels to sell!

   Liked On: 04-10-2018, 09:37 PM

7. 
   Brian liked post by Walker On thread : Eugenie Sage

   Maybe it's time to go back to first past the post, with the rate this lot are giving away money on wims and bribes we could not meet our loan obligations and there are no more jewels to sell!

   Liked On: 04-10-2018, 08:06 PM

8. 
   Boaraxa liked post by Walker On thread : Eugenie Sage

   And we're all a bunch Cunters to her! Deformation proceedings anyone!

   Liked On: 04-10-2018, 07:07 PM

9. 
   ZG47 liked post by Walker On thread : New Defence Force rifles need firing pins replaced

   From contact on the 'ground', a small batch of pins were incorrectly heat treated, so instead of suck it and see the whole lot are being replaced gratis. Those bigger companies still make the same...

   Liked On: 28-09-2018, 09:28 PM

10. 
    rewa liked post by Walker On thread : Interesting read.

    Here in NZ we are very lucky to be allowed to hunt with whatever cal and projectile we like, as all our game animals are considered pests. In most other countries what you can use is regulated to cal...

    Liked On: 10-09-2018, 12:36 AM

11. 
    shooternz liked post by Walker On thread : Nazis successfully complete invasion 70 years later

    Intrestingly going through some sociology/criminology stuff and turns out alot of the far left and right leaders have been genuine, what is now diagnosed as phycopathes. Politics seems to attract...

    Liked On: 09-09-2018, 03:06 PM

12. 
    llewelyn liked post by Walker On thread : Brownells to NZ

    Yes they do, use the USPS shipping much cheaper then other options though not always the fastest! Latest little order went to Neatherlands but now returned to US and headed in the right direction.

    Liked On: 28-08-2018, 06:55 PM

13. 
    Puffin liked post by Walker On thread : Chamber Reamers: Straight Neck or Tapered Neck

    6 ten thousands of an inch isn't much of a taper but as it's a high pressure case it will be to stop possible seperation of neck to shoulder junction by allowing body thickness brass to protrude into...

    Liked On: 28-07-2018, 08:08 PM

14. 
    Feather or Shoot liked post by Walker On thread : Chamber Reamers: Straight Neck or Tapered Neck

    Tapered necks stem from militiary design. The tapered neck allows some gas to flow around the outside of the case after the main pressure spike and aids extraction.This was developed during the early...

    Liked On: 28-07-2018, 06:13 PM

15. 
    bumblefoot liked post by Walker On thread : Scope mounts for 223 (also sighting in & scope advice.....)

    2" high is pretty much the go, warne rings are very good but somewhat expensive, the burris or leupold steels take a lot of beating.

    Liked On: 14-07-2018, 10:01 PM

Page 9 of 15 First 123456789101112131415 Last

• Jump to page: