OK, so after many years of wanting to reload i finally got my ass into gear and collected the required kit with a bit of trading and bargain hunting here there and every where. I have wanted to...
Liked On: 22-08-2023, 10:03 PM
Greetings zimmer, That got my attention so out to the shed. I measure in mm but with a little conversion back and forth two of my shell holders measure 0.125" and the other three measure 0.124"....
Liked On: 22-08-2023, 03:42 PM
.303 manufactured in 1943 by Defence Industries (DI), Canada. "Z" indicates that the powder used was nitro cellulose based rather than cordite.
Liked On: 21-08-2023, 01:40 PM
Get a little tiny sharp screwdriver and tap one side of the stubb to turn it out. Put a drop of penetrating oil or acetone ( nail polish remover) on it and leave it a few minutes before trying.
Liked On: 21-08-2023, 01:25 PM
And they are the guys society need to be terrified of. Weapon of choice in any mass murder right?
Liked On: 21-08-2023, 11:31 AM
231613 I picked these up recently, keeping my eyes out for other forest service booklets
Liked On: 20-08-2023, 10:00 PM
Hi all I’m new to the forum I’m a young 24 year old fellow hunter/outdoors fanatic, with a very very keen interest in the NZFS history and old school hunting stuff. I’m a passionate collector of old...
Liked On: 20-08-2023, 08:35 PM
Yes With all the usual caveats regarding reloading and variations in rifles. Noted difference are..... SRP Needs more powder to get same Vel Can be harder to ignite (you can get hang fires)...
Liked On: 20-08-2023, 10:13 AM
Yet to hear anything bad about the Opinel and price is right. Soo, just ordered two No 08s in SS. I'll grind the tip down a tad to make it more like a drop point. One for me and one for one of...
Liked On: 19-08-2023, 06:48 PM
so if Im reading the new improved "alteration " correctly..I take the wee grub screw out of locking ring on the redding dies,and pop a ??#7 lead bird shot in and put grub screw in again???
Liked On: 18-08-2023, 10:05 PM
Tip Redding although being top of the line dies, provide a barbaric locking ring system, that will damage the thread of your dies. Solution insert a fine piece of shotgun shot into the thread then...
Liked On: 18-08-2023, 04:58 PM
Fully agree. Redding - fantastic dies, crap locking ring system. I've replaced all Redding locking rings with the much more useful Hornady Die Locking Rings that don't have any mechanism contact with...
Liked On: 18-08-2023, 04:49 PM
Had a bloody good run out of my olight for the last 4 years, seen deer past 1k, runs all night. Would be absolutely perfect if it had abit wider beam but other than that I can't complain
Liked On: 15-08-2023, 05:34 PM
I ticked the wrong box I promise
Liked On: 15-08-2023, 10:08 AM
now where the heck did I put that list?????
Liked On: 14-08-2023, 05:59 PM