No sure about the latest Makitas. They don't always rate that well in comparison reviews. And I have older Makita (although corded) disk grinders and they have been bullet proof. I sense that battery...
Liked On: 13-05-2023, 04:23 PM
There are differing opinions amongst barrel makers re the use of bronze brushes and differing opinions re pulling them back through the muzzle/crown. All I would recommend is if you use bronze...
Liked On: 12-05-2023, 08:55 AM
I too just got an email. Not sure who its from, it's unsigned. Could be spam. Have deleted.
Liked On: 11-05-2023, 06:51 PM
In the end that's all I used to do for my 12g black powder loading. A ring of PVA around the outer edge of the over shot card. The PVA doesn't exactly stick well to the hull but I never had a card...
Liked On: 11-05-2023, 11:51 AM
Beretta buys Norma, RWS, Rottweil, Geco ZAC KURYLYK IN AMMO ON MARCH 14, 2022 Beretta has purchased one of Europe's major ammunition manufacturing groups, and will be taking control of several...
Liked On: 10-05-2023, 09:29 PM
Just be careful with old H414/W760 data as the modern powders may not be exactly the same as the old. I researched this ages ago (I'm a W760 fan) and cannot remember if W760 morphed into H414 or...
Liked On: 10-05-2023, 11:58 AM
Mate had the top rifle in post #4. I always thought it was ugly with the bit between the trigger guard and the mag. On reflection it probably served a purpose though and the long mag was less hangy...
Liked On: 07-05-2023, 07:18 PM
Yep, all those making points about visible means of placating non firearm owners I 100% agree with. However, equally important I have found is using them amongst other shooters. I spend more of my...
Liked On: 06-05-2023, 08:23 PM
The mistake is storing powder like that. The bulk of my powder (~11kgs) is stored away from the house. I don't wish to battle with an insurance company even if my powder had nothing to do with a...
Liked On: 04-05-2023, 10:58 PM
Some dies still come in wooden boxes. There is a South African gunsmith who manufactures very sophisticated and expensive dies and they are packaged in a wooden box. The wooden box itself is a...
Liked On: 04-05-2023, 02:09 PM
If you've got a couple of FLS dies and you seemingly haven't it's dead easy to do rough measurements with your vernier calipers into the mouth of the die and then compare between dies. Also compare...
Liked On: 04-05-2023, 02:09 PM
Is that rifle going to slide off that post......
Liked On: 04-05-2023, 12:39 PM
I can remember a ring ding. Is that the noise they made if you revved them up and took your foot off the accerator? Classic 2 stroke noise. The mine I worked in had one dropped off to trial by...
Liked On: 04-05-2023, 08:40 AM
Wind unfortunately is a major issue where I live, and not all have access to long indoor ranges. Most indoor ranges here are the tradional 25 yard ranges and are one night a week smallbore club type...
Liked On: 02-05-2023, 08:47 PM
Yep, all those making points about visible means of placating non firearm owners I 100% agree with. However, equally important I have found is using them amongst other shooters. I spend more of my...
Liked On: 02-05-2023, 07:18 PM