Search:

Greetings,
Found an unfired Denver 42 cartridge which measured 11.85mm, the same as the GFL .308 cases I measured. The .30-06 military cases were designed to be fired in machine guns so are likely...

Greetings,
The base dia on the 9.3x62 is 12.10mm versus 11.95mm for the .30-06. .308W cases on my bench ran from 11.85mm for GFL down to 11.80mm for Winchester. .30-06 cases would likely be similar...

Greetings JohnDuxbury,
This is one of the challenges of loading for European cartridges in a European rifle using US data The European rifles often have larger groove dimensions and sometimes...

Greetings Friwi,
My son grabbed his 350 RM headed out the door at Kiwi Saddle while I and the two others in the hut chatted. Seconds later kaboom, my son had shot a Sika hind about 50 metres from...

Greetings JohnDuxbury,
I have come up completely empty on data for AR2207 in the 9.3x62. The nearest I got was some data for H322, AR2219 in a wildcat 9.3 on the 350 Rem Mag case developed by John...

Greetings,
The old ADI/ Mulwex data is all over the place with little, if any of it having been pressure tested. There were still some of the super hot loads in their manual as late as 2000. ADI...

Greetings,
That is some interesting data. Based on that the 48 grain load of AR2207 looks a bit stout but perhaps not so much with the PPU projectile which is likely to be softer. A better longer...

Greetings again,
I had a look on Loaddata,com and in the back issues of Handloader and found plenty of data but none whatsoever for AR2207/H4198. There was quite a bit for IMR3031 though.
GPM....

Greetings,
I remember a number of articles in Handloader on the 9.3x62 30 plus years back so had a look on Load data dot com but nothing for H4198/ AR2207. IMR3031 was about the closest. Will have a...