Welcome guest, is this your first visit? Create Account now to join.
  • Login:

Welcome to the NZ Hunting and Shooting Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

Search Forums

Advanced Search
ZeroPak DPT


Search:

Type: Posts; User: Maca49

Search: Search took 0.03 seconds.

  1. 20-04-2014, 07:07 PM

    Thread: Shotgun-9mm thing

    by Maca49
    Replies
    223
    Views
    26,853

    Weld a bit of 6 mm steel to the face of the block...

    Weld a bit of 6 mm steel to the face of the block and extend the firing pin!;)
  2. 19-04-2014, 06:37 PM

    Thread: Shotgun-9mm thing

    by Maca49
    Replies
    223
    Views
    26,853

    Well that will go well!:roll:

    Well that will go well!:roll:
  3. 19-04-2014, 06:07 PM

    Thread: Shotgun-9mm thing

    by Maca49
    Replies
    223
    Views
    26,853

    If you have a half decent lathe you'll be able to...

    If you have a half decent lathe you'll be able to cut a thread on it. Just get a good lathe book and nut it out, tooling is usually the expensive bit if you don't have any, if you need anything like...
  4. 20-01-2014, 08:44 AM

    Thread: Shotgun-9mm thing

    by Maca49
    Replies
    223
    Views
    26,853

    Laser the barrel off Toby, cleaner finish,...

    Laser the barrel off Toby, cleaner finish, Grinder should crown it just right, Hacksaw, then file? or turn in lathe:wtfsmilie:
Results 1 to 4 of 4
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
All times are GMT +13. The time now is 09:30 AM.