Search:

Is this for me? If so. I don't think so. I was single loading as having a little issue with the feed rails and the 3rd round jumping out.

Next i am back in the country i might give 2217 a crack. 2 magpies from 3 shots yesterday at the hugely challenging range of 150y ish. So far that loads will have to do.Until next time. Cheers for...

That's impressive. Cheers.

Ended up going up to max load with still no pressure signs. Tried seating out to fit the mag box but not enough in the neck so tried 68,69 and 71mm.
This was the result with 73.5gr of ADi 2225 at...

Ill try a few more loads then play with the seating depth. I appreciate the help and hoping in the next week post a result.
Cheers

I am not seating the projectiles as shown in the photo. That was just to show where the lands where. If I seated it 3mm deeper it would fit the mag box with room to spare. Which would give about 7mm...

I was checking the brass as I went. No flat primers and no marks from the ejector pin. A little crater around the firing pin but it is a Remington and it isn't in the centre. So guessing the hole is...

Thanks for all the replies. The squares are 25mm/ 1" so not that small. And at 100 yards.

The towel just helps when firing off 20-25 rounds in one sitting. But no don't generally hunting with a...

Thanks for the reply.

Hunting mainly but always nice to have a shot at the gongs as well. Or most other pests that happen to land at the range.

I would normally try for a still day but just...

Evening.

Been trying to find a load for my 22" barrel Rem 700 7mm Rem Mag. Wondering if you intelligent buggers might be able to offer some advice.

Using 2225 and Federal Magnum Match primers...