Search:

Was just re reading this thread and saw your question re 7mmwsm tonyd . Loaded max adi load in a friend's 24" rem 700 with 162eldx for 2940fps~. Only shoots about an inch but ES is reasonably good...

nickbop

Cameromjackwhite

What is the load? Cheers mate

Monk Sako85 how do you guys find those 178 eldx go up close? Mate is about to build a 20" 300wsm like your ones and he is sold on that bullet so trying to get info for him. Cheers

So went and saw chainsaw who was good enough to help me out. Looks like I need to ream the neck again ffs. Loaded ammo measuring 0.3155" would not chamber so think I will get it opened up to 0.317 or...

sneeze we crushed the first round and then backed it right off so that is not the issue we think. r87mm will check when I do some more loading mid week(have to do it at a mates and he is not local to...

GWH looking at the cost of a neck Turner it would be cheaper for me to have it rechambered!

Unsure what the neck was chambered too as gunworks just swapped the barrels over. Will look into neck turning as never done that before. Cheers bro

Empty brass goes in mint but soon as you load a pill it is a major struggle or will not go at all. Will measure before and after tomorrow. No way to measure coal to lanz but seems to be more of a...

Come to the conclusion the brass is too long after comparing with saami specs so I have just ordered a case trimmer from gunworks. If that does not work I may have to get the chamber opened up which...

Back to not being very sure now. Will keep the viewers posted....

Nope and nope. Finally figure it out and it is throated VERY short...

Well this is not ideal. Run the brass through a fl resizing die(brass happily Chambers) but as soon as I load up a round it will not chamber at all. Anyone have any ideas???? Losing my mind at the...

105909 19" 284 tikka with dpt mag suppressor, 20moa rail and sightron stac 3-16x42. Reloading starts this week

Hey guys gun should be getting put together this week. Have a 25-06 tikka and a 20" 284 barrel. Does the gunsmith just screw the barrel onto the existing rifle and it is done? Length wise I am...

Shit that is pretty epic. The eldm is actually a projectile I have been looking at a bit along with the 150gr eldx and nosler BT. Mostly mostly shoot reds and fallow so matter of finding which pill...

Those 142lrabs could be the goer then

OK all you 284 oficionados I am part way there to making this project happen thanks to a very helpful forum member! Once it all comes together I will be using as my go to 0-600m hunting rifle as well...

Take it the 284 bbl is gone? Stop buying all the good shit Neil!

How do you even get a tikka 284 these days. I thought gunsmiths refused to work on them?