In the end I was lubing the hell out of them to the point I became worried about dented shoulders
Type: Posts; User: Ryan_Songhurst
In the end I was lubing the hell out of them to the point I became worried about dented shoulders
Bought some new dies this morning, also RCBS as thats all I could find on the shelf in chch, set them up exactly the same as I had the other ones and brass is running through them nicely, I had a...
What do you man by wind down VC? Wind the die down further? I have it setup so that shellholder stops on bottom of the die as per instructions with the dies... They seem to be sizing to spec well I...
Shouldnt be a lube problem, i dip all the necks in graphite and lube case with Unique, never had a problem with that routine before
So i managed to pick up a new caliper today and just had a measure up, the dies seem to be sizing the brass to spec pretty good, and the brass doesn't seem to be getting excessively stretched during...
Prior to sizing they all chamber fine, they were all new norma cases and have only been fired through my rifle, they were originally sized and loaded through Hornady new dimension dies. I never had a...
After one firing?
Nah mate, fired primers in all the brass, and I have only used that brass once, it was all brand spankers at Tobys shoot last year in fact. if it was already sized I would expect it to be even easier...
Will try pick up a caliper tomorrow and see what I come up with, had a quick look for my other one this evening but I'm buggered if I know where I have put it, have stopped sizing for now as I don't...
Took the button and shaft out of the die and its still really hard to push it up that last few mm
? no
Has anyone had trouble with RCBS dies? I have a set (FL sizer and seating die) that I bought a while back as I thought they might be a bit better than the Hornady New Dimension dies I was using....