Search:

Mystery solved.
I somehow believed I had a solid measure of the max COAL as 2.328 and rolled with totally (blind) confidence.
Got a more experienced mate measured my max COAL to be around 2.291 and...

Great suggestion mate, I was just looking for check weights to buy, but actually having a projectile would be good to use as a nice and cheap check weight. Cheers!

Sadly got no other powder I could try :(
Did suspect things might have gone wrong but the smell was fine though. The smell test was the only test I found on internet.

Thanks a lot for the tips team. Lesson learnt here: go mechanical or go hellla expensive.
While we are on this buzz, I've got the Hornady calliper as well, is that all good though?:XD:

Hornady 1500 G2, I know it is not that flash but could it be out by that much though?
I did rattle the cartridge after loading them and I gotta admit they sounded like they had a lot of space in...

Thank you very much and this Quickload looks like an incredibly useful tool.

Thanks a lot team
I've checked the chrono, a guy on site put his labradar next to my rifle and the reading was consistent. GWH yes it's the one I bought from you, it's shot factory ammo amazing, I...

So tested my luck with reloading recently, apparently not so good.
Though getting easy MOA or sub but the speed was way low. With 6.5 Grendel I was aiming for above 2500fps and I was getting around...

Cheers for the tips team, think I'll get on with developing and just adjust for POI once fitted then!

Cheers for the tips team, I'll hold off on load development until I acquire suppressor(s) then.
Meanwhile I'll also examine the possibility of moving to Aus :XD:

New to reloading here. Basically contemplating (as in short on funds) about getting suppressors for couple of my rifles but also wanna do load development for them.
In your experience does...

Got a couple rifles I wanna thread and get suppressors for, one is a 308 and tip of muzzle measured 0.574 inch, another is a 6.5 grendel tip is about same width.
Just wondering what are the possible...

Anyone got experience with Frontier Projectiles? I'm looking at their 9mm 124gr. Either Round Nose or Flat nose will do.
Think I saw another member's post on their .429 projectiles before, that...

Well spotted:XD:

Hi Everyone

Name is Michael, lives in Auckland.
Recently handed in my Master's thesis, and have been in army reserve for a few years.
Got my FAL last year but still haven't much experience with...