Search:

Blaser do a 9.3x62

Yeah the guy that made that one is pretty talented. Search Dorleac & Dorleac.

csmiffy the BSA Model E/p14 can be made into a beautiful rifle. This one is in 416 Rigby

89455

89456

Range of the 9.3 depends a bit on the projectile. If you use a 250gr accubond you are probably good to 300yds. I shot a red stag with mine at 97yds with a 286gr prvi.
With the right powder you can...

Fireflite here is some CZ FS specific data 9.3x62 and re-loads - Graybeard Outdoors

Hi dakota elk slayer,

The lightest bullet I have used is 270 gr. However I have gotten good result using...

Here is some
You can easily extrapolate from Hodgdon's data.
They list for BLC2:

I use BLC2 in my own 9.3x62 it delivers higher speeds than Hodgdon's data shows. Hodgdon shows the same data for...

Bugger, you might need to be a member.

Another good 9.3x62 reloading thread, also some other links in it

Forums.NitroExpress.com

Here is the BLC-2 data Forums.NitroExpress.com

Nitroexpress.com I'll see if I can find the thread

I'm using 56gr 2208 with 286gr Prvi getting about 2250fps from 24" barrel. Apparently BLC-(2) is the best powder for velocity.

Nice, there was story on Africahunting recently about a guy shooting 2 giraffe with his 9.3x62. He had no issues.

@Mart Henry shooternz sells them, Check on trademe, he usually has them there.

300_BLK post #259 back on page 18

This will help you decide which projectile (pics stolen from Nitroexpress.com)

74826
74827
74828

Shouldn't be too bad a few European makers like Blaser do 9.3x62 in short barrels. Might be closer to 20" rather than 16" though. BLC-2 is suppose to be amazing with the 9.3x62, that is a reasonably...

The 286gr prvi works well and is cheap too. Gunworks has/had them for $86 for 100 projectiles.

john m akaroa1 this might explain the projectile differences. Note the pics are not mine, I "borrowed" them from nitroexpress.com

64909

My 1924 Mauser has no cross bolts and the stock is fine apart from a small chip at the tang.
You probably will find a peep on the bases will be too high for the front sight, but I think Talley do a...

Nearly done

Go for it outdoorlad

All here. Gunworks have Prvi 286gr RN projectiles for about $90 a 100. A few places have lapua brass Gunworks, workshopinnovations

56gr 2208 with a 286gr Prvi gives 2260ish in my Mauser.

What's your load/muzzle velocity.
My open sight Mauser with a 286gr doing a leisurely 2200fps has about 23" drop at 200yds from a 100yd zero.

I haven't had mine out since I shot a stag in April.