Vinnie Jones / bullet tooth Tony :P
Type: Posts; User: ebf
Vinnie Jones / bullet tooth Tony :P
Marty, check the regional/district plan as well. Facilities for shooting sports are sometimes written into these. I doubt it would be common, but I know of at least one where this is the case....
It is range certification not registration...
I've added some comments in red above
Broadly yes, but where the system becomes too onerous or the bar is set so high that most volunteer run ranges have difficulty complying, I do see it being a problem...
From my perspective...
I understand what you are saying, but we live in a brave new world...
The point I am making is : don't make it a bigger issue than it needs to be.
Going forward, the major concern I have is the...
Regarding the "officer on duty" thing for casual use.
It really does not need to be as complex as most guys are making it.
HVNZDA have been running a system for several years where we have an...
GPC, the 900m width is just (soft) ground ricochet. If you include hard ricochet surfaces, that increases to over 1600m wide.
The blocks on the T6 template are 400x400m squares.
Hahahaha, Doghead, logic or actual risk has almost nothing to do with any of this.
It is simply a massive new bureaucracy - very similar to WorkSafe...
Data – Rifle – ADI World Class Powders and Ammunition
You have much to learn Padawan :P
217970
TeRei, it depends on what brand of dies you are using. Some FL dies without an expander would squeeze the neck down so much that the case becomes useless.
I'll repeat my mantra : MEASURE.
The...
True shoulder bump sizing as it is used in benchrest and target reloading does not use a FL die (unless the neck portion has been reamed out, making it a body die).
What you are describing above...
Size, fire, size, fire, size, fire...
Think of it this way:
If you measure the case and the shoulder datum is correct, but the case wont chamber, then something else is out of spec, right ?...
Ok, so here is an experiment for you.
Get a shoulder bump / body die that is correctly set up. After firing, size your case, but DO NOT trim it. Keep doing this for several iterations. At some...
Add to this that when you start using expander buttons in sizing dies things get even more complex.
I don't like expanders at all. For shoulder bumping I either buy body dies, or make them by...
All of these issues can be identified and correct by doing the appropriate measurement.
I don't really agree with this BW. The case may well have been sized correctly, but during that process,...
Stunning :drool:
Sad news indeed :(
Owen was often the voice of reason when things got a bit heated on the forum.
RIP
Yup, I have a growing collection of Husky 36s (I refuse to admit that I have a chainsaw buying problem...)
One of the "parts" saws I have here has similar issue, not as terminal as the one above,...
I stuck with 2208 for both 162 and 120, needed couple more grains of powder for the light pills.
Hi Ernie,
Not a bench, two individual seats, but basic form, not bucket seats. That's a lot more palatable than the price of the Rugge Valley ones ($ 450)
I chopped one of my 708 barrels to 14 inches.
162 Amax no longer worked, ended up using 120 grain
Hey M, this is for my white van, not the ute (Bounty), tx.
Got a little Suz APV van I use for work. Basic seats, not bucket.. Has a detachable headrest.
The driver side factory seat cover is starting to go.
Any recommendations for heavy duty canvas...
whanahuia, what you typed in above sounds fairly reasonable...
when you dig into it a little deeper, the reality is unfortunately a bit more complex.
most guys involved in service rifle will be...