Im using all the litz I can now and validation has never being so easy
Type: Posts; User: Kelton
Im using all the litz I can now and validation has never being so easy
Just ran it threw appied ballistics with a couple of guesses ie zero range of 100yds and scope height of 1.5inch and it lines up well with your trued data Tikka7mm08
The litz bc is .571 im using the litz bc for the 180eldm of .707 rather than the .796 from honardy and the speed from magneto speed and elevation is spot on to my tested 800 yards be intresting to...
Interesting what was your 26 speed and charge? I was under the impression it’d be no good because iv being told no good in saum good to see some real world
I act on the side of caution now I was lucky to have no accidents. Theirs no requirements,formwork or education around reloading safe practices required here in NZ I don’t no if their is anywhere in...
That’s way to hot mate dangerously fast for the combo my 6.5 saum did 3080fps with the 156 with rl26 and that was hot backed down to 3000 the saum has greater case capacity and rl26 is faster for...
My own little rule of thumb where these three powders are applicable is under 70gns RL26 and fed 210 over 70gn either 2225 or 2217 and fed 215 it’s not the rules but iv found it to work very well...
You obviously aware to be vigilant with temp/pressure spikes then other than that it’s a fantastic powder and goes threw auto machines very well
2225 is no good mate N560 is good and Superformance is another
A fair bit slower I imagen would run out of room before you’d get to 3000 I would think and pressure would be up their
It’ll speed up I’m sure my barrel did and still is wouldn’t be surprised if you gain another 100fps I think the Hornady data is optimistic the prc is more of a humble velocity accurate cartridge...
How longs the barrel Tikka7mm08 lots of promise mate