Not in this chamber its not.
Attachment 9568
Sent from my GT-S5360T using Tapatalk 2
Printable View
Not in this chamber its not.
Attachment 9568
Sent from my GT-S5360T using Tapatalk 2
I won't say anymore than it is /was a paint tank.
Sent from my GT-S5360T using Tapatalk 2
Bite the said tongue. ...
I'm with Cam. Lost like everyone else since your 1st post LOL
Again. . . .
Primer pockets don't loosen themselves:)
Harder brass is trying to hide it. . . . .
I posted someone's pet load. . . . .
then posted ways around high pressure to make a fast safe load. . . . . Simple to me? No
Sent from my GT-I9300T using Tapatalk 2
Na you didn't you posted two loads with no pressure data and didn't state if they were any chamber powder brass primer changes just this one is more powder and less pressure.
I can put 52 gr of 2208 in a 308 case with no pressure signs but i sure as Fuck wouldn't even try that with n140 both of which are the same proposed burn rate .
Sent from my GT-S5360T using Tapatalk 2
Ie you didn't show ways around anything at all
Sent from my GT-S5360T using Tapatalk 2
There i said it.......in the first post
SAME primer
SAME cases
SAME powder
SAME projectile
MORE powder
So where did the excuess pressure go?
Why would i tell everyone the little bits i done to reduce the pressure?
I showed everything that was needed................
My RUM ended up with 100+ faster and 5 more grains in it for less indicated pressure on same brass