If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
Thanks all you guys
This project has been ripping along and I now feel confident to start some load work once I get in to Gunworks and pick up some FFG
I doubt it's been fired for the best part of a century
My thinking I'd brass would have been a huge challenge in the past.
We are living in a time now where CNC machining and the internet are making these historic firearms usable again
Don’t tell Nash about the CNC bit, here’s some foam wads I used in my smokeless BP loads on the 500
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks