Printable View
Been looking around for a while now for a new trimmer and am thinking that the Forster original trimmer will be a good choice. I was also thinking of adding the 3 in 1 cutter in attempt to save some time deburring and chamfering..... I will most likely add a power adapter as well.
Anyone used one and have an opinion to share?
Personally, I think those types of case trimmers are overpriced for what they are, so made my own.
http://iforce.co.nz/i/4ec0xmx5.erk.jpg
Basically its a stepper motor with a $12 drill chuck whacked on the end. I had made a motor driver out of stuff I already had plus a few extras. A few budget lee accessories and whallah! Motorised case trimmer for roughly half the cost
They look good. I have contemplated buying the same trimming system.
At the moment I use the Lee Quick Trim Deluxe with power adaptor, which is similar in that it trims, chamfers and deburrs in the one cut.
If you buy a forster I will be keen to hear how well it works.
Yes, I have used one for 25-odd years and it has been perfectly adequate for trimming over that time.
I don't recommend it for the neck turning add-on though - if your thoughts were tending in that direction as well ?
Cordless drill, far more versatile :DQuote:
Originally Posted by AlexW
Thats definately an option, but this way is much more stable/less awkward. And I dont need to deal with batteries etcQuote:
Originally Posted by Gibo
Mate I use the hornady with the power attachment for cordless drills but you still need the pilots and shell holders. It's good don't get me wrong but I would recommend the RCBS with the paddle which uses a generic plate to hold most cases. It saves on shell holders and mucking about.
Or if your game the worlds finest trimmers from little crow Gunworks is awesome and fits a drill
I just use trim dies, work pretty good, simple and easy to set up and use
Two trains of thought, trim dies like what Ryan said but if you want to do more, and I add at far greater cost, then forster or century 21 etc will do other things as well.
I have a forster trimmer and use it for necks as well as trim to length. It makes a far nicer job of neck turning than some of the hand held units I have seen used.
If all you want to do is keep case length optimum go with the trim dies or the lee mandrel system as shown with the drill pic like Alex is using.
If you use a forster to trim to length more than 1 case style it can be a bitch to get set to the next length.
Main problem I have found is that one of the cases I want to trim doesnt have the likes of a lee trim die or a bushing for say the wft trimmer (7mm Blaser) hense looking at the forster or more universal setup. I havent really checked out the rcbs one, will take a look at it. Nice DIY option there but limited to common cases no? 🤔
Yeah at the moment it is, I'm only focussing on .223 for starters. I'm sure lee sells shell holders/pilots for most calibers, unless you're shooting something really oddballQuote:
Originally Posted by Donald