Thread: HRBC bullets

Originally Posted by T.FOYE

Doing a resize on the pc seems to make it a bit more delicate. If you can size using water as lubricant, dry them and coat. That should make the pc a bit more resilient. Had a few issues with both .458 and .311 cracking off during seating...

Not sure how this applies to HRBC but yes an interesting consideration when rolling ones own. Haven't done it yet but seems most size after PC applied. I think if I was going after higher velocity, hardcast say, PC after sizing might be worth trying. But also likely to combine with a GC. Two trips through Sizer to fit GC? Or PC over GC? Fitting GC after PC comes back to the issue you raise but maybe weaker PC doesn't matter when GC also used.