Thread: White River Primers - Any misfire issues?

Update

Took my bolt apart and had a look - pretty bloody clean and spring is nice and strong. Firing pin looks good. I should relax it as per MD

Cases - left to right
2x Fed210 that fired Win760 with 162 ELDX
2x WRE that fired RE16 with 140 BTs
2x WRE same as above that didn’t ignite

Firing pin strikes look good to me.

Attachment 257160

Also one more WRE that did fire and 2 x loaded rounds

Attachment 257161

Found my old school hammer bullet puller and dismantled the two that didn’t ignite. They had powder (killed me to tip RE16 in the garden) and cases/primer hole was fine. Dropped one primer on a messy floor but this is one I recovered - looks fine other than not gone off!




No obvious answer to me yet