Thread: Atlasworx A7 Bottom metal

These have been mentioned a couple of times on here over the Last little while. Is there anyone out there using one? I've done some research and would be grateful to get some real world answers from a reliable source.

How much inletting is involved? Approximate cost of inletting? Any recommendations as to who does the inletting?

I've heard only metal aics mags work with the DBM. What brand are you using? With or without the binder plate?

The atlasworx action bolts are meant to be an improvement on the factory ones, anyone tried them.

Lastly, does it feed well? And what's the finish like, quality product?

Thanks

Stacey

I have the bottom metal replacement so still use the original mag it went straight in. The aics ones came out about 6 months after I got mine but if I loose the mag I'm going to replace my current one. Cheaper then getting a mag. There are a couple of YouTube vids floating around mainly the remington ones though