If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
Had a case for a while, rain day so cut slots with a hot screwdriver, not very well,(stock and barrel without sights) bought a electric soldering gun with hot knife for the tip, did a better job on the scope and upper barrel, but runs too cold and difficult to keep going, might get another foam and try again sometime.
But K95 with 3 barrels and 3 scopes. Attachment 247334
I use a craft knife fully extended and keep heating that up red hot with a butane torch, cuts through it very cleanly and quickly.
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks