1Likes
LinkBack URL
About LinkBacksHey Shamus - all factory Hornady SP and V-max 55 Grainers... All fired happily - I just noticed the fault when cleaning the bolt otherwise cycling ok except for taking a few little burs off the bottom of the brass where it contacts the edge..
The only ramp is missing and the overhang of the bolt that holds the rounds in place has not cracked any further than that just has taken a chip off the edge...
Any suggestions as to a local gunsmith worthy of this type of work in the Auckland area so I can get it to them Tuesday???
Thanks guys for your comments and help thus far!
P.
Welcome guest, is this your first visit? Create Account now to join.
Welcome to the NZ Hunting and Shooting Forums.
Search Forums
User Tag List
Results 1 to 10 of 10
Threaded View
-
25-10-2014, 10:12 AM #5Member
- Join Date
- Feb 2014
- Location
- The foothills of the Waitak's
- Posts
- 1,212
Reply With QuoteTags for this Thread
- 22-250,
- 223,
- 303,
- 700,
- action,
- advice,
- ammo,
- bolt,
- brass,
- bright,
- cans,
- carbon,
- case,
- chamber,
- chip,
- cleaning,
- extractor,
- face,
- fired,
- gunsmith,
- gunsmithing,
- install,
- kaipara,
- laser,
- mae,
- magazine,
- poi,
- reloading,
- remington,
- remington 700,
- rifle,
- road,
- round,
- rounds,
- safe,
- safety,
- sako,
- short action,
- smith,
- tempering,
- warranty
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
All times are GMT +13. The time now is 10:35 PM.
Bookmarks