Thread: Looking for a Brno vz. 24 extractor

It was actually "modified" to close on a round not picked up from the magazine and eject it etc, which worked fine until it broke...

Cheers for the info, I'm still hoping there will be an extractor or even a bolt/parts gun floating around for me (fingers crossed). Will resort to the weld and reshape if I have to.

Originally Posted by Nic

It was actually "modified" to close on a round not picked up from the magazine and eject it etc, which worked fine until it broke...

Cheers for the info, I'm still hoping there will be an extractor or even a bolt/parts gun floating around for me (fingers crossed). Will resort to the weld and reshape if I have to.

Bugger. If it helps I can take a pic of my mod? One thing that might stuff you up here is the relief cut in the front of the receiver ring that fits around the tip of the extractor. Depending on what you have, it may or may not clear the tip of the extractor as it tries to snap over the rim when you close the bolt. My M48a did have clearance, but if yours is marginal you might be squeezing the tip of the extractor on both sides which is not great for the life of the extractor...

Yeah a picture might help if I end up going down that road, thanks.

Originally Posted by Nic

Yeah a picture might help if I end up going down that road, thanks.

@Nic




Quite a bit off the back of the extractor...