Thread: Ruger 10/22 - Tricks, tips and modifications

Originally Posted by gundoc

I put the barrel in the lathe and run a light knurl on the barrel shank to increase the diameter to a firm push fit, smear retaining grade Loctite on the shank and press in place (taking care to get correct alignment) then refit the barrel clamp with some normal grade Loctite on the screws. The barrel can be removed with heat to break down the Loctite, but no real reason exists to ever take the barrel out again unless it has been damaged. The standard Ruger barrels are perfectly accurate but minute movement between the barrel and the receiver (that has the scope attached) are the cause of their mediocre accuracy as they come from the factory. The late model 10/22's have a tighter barrel fit than the early ones. The standard triggers are also perfectly good subject to being given a good trigger job (not a job for amateurs).

You worked over the trigger and did a barrel chop, thread and put one of your suppressors on my fathers 10/22. Its a fantastic shooter. When you were still in the city.