Has anyone got one? Long-term reports? Looking at the 11XP.
Printable View
Has anyone got one? Long-term reports? Looking at the 11XP.
I've had a couple mates run them and with quite a lot of use out lasted the warn winches they replaced.
I ve had a couple. First one got a bit noisy but sold the vehicle and had no complaint.
Second I stripped before fitting. Added grease to a few spots that had none. Just me being pedantic but also wanted to see how it worked
It spent a bit of time under water and never failed had it from 2012 to just last weekend actually. Pulled a few trees and other bits.
No problems at all
MCC NZ Agents ? They sell bulk winch bars also. Good to deal with. Only complaint has been the paint on their bars is not long lasting
two or three years and they rust or fade out. Typical Northern Hemisphere paint sent down under :O_O:
Sounds like ok feedback so far, anyone else?
Have you done a search back on the topic Gimp? I recall a previous thread about them and something about not sealed correctly and lack of grease, of which has been mentioned.Quote:
Originally Posted by gimp
I've had a few, most recent one was their high speed comp winch at 9500lb. It was missing seals from factory which led to the motor rusting out. They reconditioned it at their cost, it lasted two more months. Moral? check it out completely when you get one, disassemble it and check all seals are in there. Gearbox lubricant can be lacking too, Add a decent dollop of Moreys and it seems to be sweet.
From the 4wd groups I associate with, most reports are good with the odd horror storey, but again the horror would have been found earlier if they had stripped the winch and given it a once over when purchased.
I am currently running a novawin unit, a bit pricier but still cheaper than Warn, Superwinch, Ramsey etc.
Is it working though... :thumbsup:Quote:
Originally Posted by ROKTOY
So what other brands are recommended in a winch? I've used Warn, Iron Man & Superwinch in Oz and found them all to eventually get full of rust/dust when doing a lot of water crossings and fail/need a cleanup internally. Not intending to use it intensively - be ideal if it was never used at all (except to test occasionally)
How about a tirfor winch? A little bit more effort, but way cheaper if you don't think you will use it much. I've had mine nearly 20 years and it is still in fantastic condition ( but I haven't used it much in last 10 years)
Plus you can throw it in your mates 4wd for that day trip, and much easier to swap over when you trade up to the next uteQuote:
Originally Posted by stug
Why don't you get a multi mount base that fits into a standard removable tow bar mount.
I have a 9000 lb Warne thats been on my last 3 Hilux's and is 25 years old.
Carry it in the truck only when Im away in the mountains.
Fits the front or rear tow bar receiver.
Have a heavy wiring loom that that has electric forklift connectors at both ends and a master switch under the bonnet thats also been on the last three trucks. Just change it over when I get a new truck.
That way its never been under water.
Can be fitted front or back only when needed.
Can also be used on any other vehicle as I have an additional set of fly leeds that can be carried.
Main thing is you don't loose money leaving it in a vehicle every time you upgrade and as I said its never been under water.
Easy to make a mount up or have a handy mate with a welder make one.
Great way to use cheaper winch and not have the same issues with rust etc.
This image is not my one but very similar.
Attachment 74312
As a note also.
Modern 4x4s need a heavy earth lead to the winch from the battery as the earth to chassis is very light now and you can not pull enough current through them.
Kingone
@gimp mate have a good read of this, I'm pretty sure it's the article that I think might be a good read, some of the brands may be a little dated or not available in NZ but...... the point of the article is something really important, the warranty and how they are voided! Not all great winches have great after sales support and Given our NZ terrain is and the crossing of rivers it's a factor well worth considering.
Winch Warranty's who to support and when to walk, WARN,Smittybilt,Runva,Ironman,Tmax etc | 4x4Earth
I think that there may be links to how to better seal or waterproofing plus even breather tubes??? I'm not going to tell you the brand a mate of mine uses and the absolute stunning work it's done, it was a lot cheaper but with a little after purchase care and waterproofing it's been a beast!! But you'll all take the piss!!!
Plus you sold that shotgun yet??
There are so many things I like about this set up and is the way I've thought about doing it in the past. A number of the people I've seen winch themselves out was because they got hung up, ... on the winch sticking out the front (and stuck on the towbar at the back stopping traction). So many set ups bugger up your approach angle. Particularly the factory mechanical winches on the likes of the old cruisers and safaris.Quote:
Originally Posted by akaroa1
Iv had a runva 11xp on my truck for the last 3 years. Never had an issue with it and it's had a fair amount of use. I only went with a runva because I got an awesome deal on it when I purchased a bullbar, but I'd happily buy another if I was in the market for one
-Not keen on Tirfor as I have limited space inside the truck and I want something that will always be on board, so I don't get caught out with the old 'Oh I won't need that this time' 'whups'
-Have a Hi-lift jack and gear to use it for winching as a mechanical backup (this is why I haven't bothered to buy a winch yet)
-Have an ARB bar so I'm set up for a conventional winch mounting setup already, not willing to spend more on new barwork etc, won't be any change to my approach angle
Will test anything I get every so often (probably before trips where it may be needed) & am comfortable taking a winch apart and greasing the heck out of it.
@Tertle - nope, haven't really been tryingQuote:
Originally Posted by Tertle
Got a terrain tamer 9500lb been on for 18months and used a dozen or so times. Seems to work and haven't done any maintance on it yet
It is now... wasn't then...Quote:
Originally Posted by 223nut
