Help required - Another squeaking Tatonka pack

Before the roar kicks off I want to sort out a few annoying squeaks in my Tatonka Bison 90+10 pack. I have three separate areas on the pack that make a noise.

With the application of some food grade silicone I can sort two of the areas, being the the alloy pack frame itself as it rubs along the frame sleeve, and also and where the alloy frame joins into the hip belt.

The remaining (and noisiest) area is located inside the X1 harness near the Velcro strap that attaches to the pack. As far as I can feel with my fingers it seems there is a piece of hard plastics that the Velcro is sewn into and that extends into the left and right pack strap. The padding of the respective straps which surrounds the plastic squeaks under movement when it contacts the plastic

Location of the hard plastic causing the squeaking highlighted below:

Attachment 243746

Now, a question for the experts, as I cannot easily access the area to apply silicone, would a aerosol spray like WD40 silicone spray with an applicator punched through the webbing work to alleviate the noise, or are there other remedies out there e.g. soaking it in some sort of lubricant?

Can you prise any of the layers above it apart, and drip candle wax in there?? Hot candle wax will embed itself in the soft layers, and if you can apply it opposite the hard plastic, it should lubricate the affected area.

lay it on the ground - get large branch and give it a damn good thrashing - you naughty naughty pack - may not fix it but you will feel better - nah seriously silicone - try injecting it with a needle and syringe - less damage to pack -

You actually can take that piece of plastic out, did that once to clean the pack. Never ever going to do that again.

I guess your best bet is to sell the shite-tonka and get a proper backpack.

Quote:

---

Originally Posted by STC

You actually can take that piece of plastic out, did that once to clean the pack. Never ever going to do that again.

I guess your best bet is to sell the shite-tonka and get a proper backpack.

---

Forgot to mention that you access it from the inside of the pack, there is a small zipper

Quote:

---

Originally Posted by STC

Forgot to mention that you access it from the inside of the pack, there is a small zipper

---

Thanks, it's not coming from the internal plastic 'frame' (which I have removed a couple of times, when cleaning blood from the pack), but the actual harness strap on either side of the X1 logo.
Attachment 243759

If it’s not going to be in an uncomfortable position, would it be a possibility to whip a cable tie on there and crank it up tight. If the squeak is coming from movement between the internal components, a cable tie might sufficiently anchor them together to stop that movement?

Quote:

---

Originally Posted by Kimber 7mm-08

Thanks, it's not coming from the internal plastic 'frame' (which I have removed a couple of times, when cleaning blood from the pack), but the actual harness strap on either side of the X1 logo.
Attachment 243759

---

Oh! Sorry!

UPDATE

I got some WD40 Silicone Spray on Saturday and sprayed it into either side of the plastic causing the squeaking. Could not insert spray nozzle into the material as much as I wanted to, but the area was well coated and after drying off for a day, it seems like it has done the trick. Fabric still a little darker looking after the spray and has a faint smell, but I can live with that if the squeak stays away!