Welcome guest, is this your first visit? Create Account now to join.
  • Login:

Welcome to the NZ Hunting and Shooting Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

ZeroPak Alpine


User Tag List

+ Reply to Thread
Page 1 of 2 12 LastLast
Results 1 to 15 of 26
Like Tree21Likes

Thread: Using hard items as rests

  1. #1
    Member
    Join Date
    Apr 2020
    Location
    New Plymouth
    Posts
    370

    Using hard items as rests

    In general terms how much padding should you put between your rifle forend and the hard item you're using as a rest (tree, fencepost etc)

    Specifically, I want to be able to use the top of my Tatonka Stealth 35 pack as a sitting rest (Resting my rifle forend on the top of the pack while holding it steady verticle with my left hand). There is a portion of the frame that runs across the top of the pack under a couple pieces of spongey fabric. Will this be enough isolation or should I look at putting some sort of extra padding or something?

    Thanks in advance.

  2. #2
    Member
    Join Date
    Aug 2015
    Location
    West Auckland
    Posts
    1,053
    Basically, you want to replicate the rest you use while sighting in, or the point of impact may change.
    chainsaw and BSA270 like this.

  3. #3
    Sending it Gibo's Avatar
    Join Date
    Feb 2013
    Location
    The Hill
    Posts
    23,211
    Easy fix.......try it
    HNTMAD, BSA270, 40mm and 1 others like this.

  4. #4
    Jus
    Jus is offline
    Member
    Join Date
    Feb 2022
    Location
    Nelson
    Posts
    255
    Go to the range and shoot like that. In my experience it’s about recoil management/absorption. If you in the field the same as you do at the range it will work the same way. If you use a rest and rear bag at the range but shoot off a bipod and hold the Doreen’s or above the scope in the field, you will get different results bud

  5. #5
    Member
    Join Date
    Apr 2020
    Location
    New Plymouth
    Posts
    370
    Yep will try it out next time I can get to the farm but was just wondering if a hard surface would require some sort of dampening to stop vibrations or something

  6. #6
    Member
    Join Date
    Apr 2020
    Location
    New Plymouth
    Posts
    370
    I'm an accountant not an engineer as may be evident...

  7. #7
    Member Brian's Avatar
    Join Date
    Dec 2011
    Location
    Upper Hutt
    Posts
    1,331
    Use my pack frame a lot and it doesn't seem to matter that its hard.
    When your out in the steep tussock any rest is a good one.
    Trout, chainsaw, Pixie Z and 2 others like this.

  8. #8
    Member
    Join Date
    Nov 2014
    Location
    Christchuch New Zealand
    Posts
    5,876
    The only reason to worry about padding etc is so hard objects dont scratch / damage the rifle when it moves under recoil.....It would be fine resting on rocks....until it moves and the rock chews the stock....The spongy fabric you describe should be enough to stop scratching, especially seeing as the tube will likely be round....

    Think about bipods for a moment- the reason they dont scratch is they are attached to the rile itself, but other than that they are still a rigid object the rifle is resting on - it is just that under recoil, the other end of the bipod takes the movement and does not rub on the rifle so rubs on the feet instead... (Not saying to get a bipod - just that it the same situation as a rest but the rubbing occurs elsewhere....)
    Intelligence has its limits, but it appears that Stupidity knows no bounds......

  9. #9
    Member
    Join Date
    Apr 2020
    Location
    New Plymouth
    Posts
    370
    Awesome thanks that makes sense. I do have a bipod but find sitting often gives a better view over vegetation, rises etc and can involve less faffing with legs etc. Also prefer the pack for prone anyway.

  10. #10
    Member Beetroot's Avatar
    Join Date
    Apr 2013
    Location
    Morrinsville
    Posts
    2,842
    You only need enough padding to stop the rifle from rolling/rocking when on a hard surface.

    Think of it it terms of contact points, if your rifle has a rounded forend and you are on a fence post the contact patch is tiny and the rifle will cant sideway very easily.
    Or if you have a flat forend and try to shoot off an angled surface you'll also have a very small contact patch only on one side.

    You could always try it on you living room floor, place your rifle on your pack and see how steady it sits. If it's rolling all over the place then try a few different soft items and see what works the best.
    You preferably want something like a pillow that can move a bit to conform to the different surfaces, if you gett something too rigid them you'll end up with the same problem.

  11. #11
    Member
    Join Date
    Jun 2023
    Location
    waimakau
    Posts
    2,644
    Ive found that a hard rest can cause verticle stringing because the rifle bounces on the hard surface. I notice it more shooting off a concrete bench using a bipod. Put a a piece of dense foam under the bipod legs and it goes away. That my experiance anyway...
    Ranger 888, Bucko and 11mms like this.

  12. #12
    MB
    MB is offline
    Member MB's Avatar
    Join Date
    Jan 2016
    Location
    The Deerless North
    Posts
    4,359
    Anecdotally, every time I've taken an "easy" shot with the rifle rested directly on a fence post, it hasn't ended well. Even a hand between the fence post and the rifle seems to fix it.

  13. #13
    Member Micky Duck's Avatar
    Join Date
    Apr 2015
    Location
    Geraldine
    Posts
    22,821
    put your hand between frame and rifle...or rifle and stick..or rifle and tree,or rifle and rock..or rifle and post..you get the picture.
    can use some fingers on stock and some on rest if need to hang on to rest.
    Bagheera and techno retard like this.
    75/15/10 black powder matters

  14. #14
    Member
    Join Date
    Apr 2020
    Location
    New Plymouth
    Posts
    370
    Quote Originally Posted by blip View Post
    Ive found that a hard rest can cause verticle stringing because the rifle bounces on the hard surface. I notice it more shooting off a concrete bench using a bipod. Put a a piece of dense foam under the bipod legs and it goes away. That my experiance anyway...
    I actually made a little pocket bag by putting a hackysack in one of those soft sunglass bags. I put this on top of fenceposts with my 22. Works a treat.
    timattalon, csmiffy and 11mms like this.

  15. #15
    Member
    Join Date
    Jun 2023
    Location
    waimakau
    Posts
    2,644
    Thats a good idea do it with your pack as well

 

 

Similar Threads

  1. trademe cheek rests?
    By stripe147 in forum Firearms, Optics and Accessories
    Replies: 9
    Last Post: 16-08-2022, 05:50 PM
  2. Shooting rests
    By csmiffy in forum Shooting
    Replies: 9
    Last Post: 26-04-2022, 11:53 PM
  3. Replies: 12
    Last Post: 13-03-2022, 03:57 PM
  4. Check rests - any one had a play with these ?
    By chainsaw in forum Firearms, Optics and Accessories
    Replies: 8
    Last Post: 04-09-2018, 11:19 PM
  5. rear field bag rests
    By yerimaginaryM8 in forum Gear and Equipment
    Replies: 3
    Last Post: 04-02-2018, 07:53 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!