Printable View
I have built a couple of 7PRC's with one more coming, 26" 1-8, 22" 1-8.7 & 20" 1-8
https://hosting.photobucket.com/imag...720&fit=bounds
I haven't done much with this one the 22" Tikka, at this stage it looks like the 140's will do around 3250 fps & 168's 3050
https://hosting.photobucket.com/imag...720&fit=bounds
Looking forward to doing more with it this weekend :)
Wicked!
Have you tested out the 20 inch one yet?
Very keen to see what the 20” one does.
Fuk thought I was in the buy and sell forum.
Waiting on the 20", hopefully get it this weekQuote:
Originally Posted by Gkp
It is for sale :thumbsup:Quote:
Originally Posted by Magnus
Nice mate always going to be a ripper of a chambering
Are they rechamber barrels or new? Do you suspect they’ll speed up? I have absolutely no desire for one so answer only if you can be bothered just curious is all cheers
Both have new 5R Bartlein barrelsQuote:
Originally Posted by Kelton
What brass are you using Greg? Reformed 300 prc or ex 7mm blaser brass? Or the very expensive RCC?
Reformed 300 PRCQuote:
Originally Posted by Friwi
https://hosting.photobucket.com/imag...720&fit=bounds
Looking forward to getting some factory brass to see what the difference is
Have you got a photo in a standard long tikka mag? Do they fit in the L mag or is it a modded WSM mag?
They are standard magnum size so normal LA Tikka mag & bolt stop :)Quote:
Originally Posted by Tuckerbox
All the loads I have shot in both rifles are able to fit in a Tikka mag
Unfortunately no 20" barreled one yet, I did some more with the 22"
https://hosting.photobucket.com/imag...720&fit=bounds
It quite likes the A-Tip
https://hosting.photobucket.com/imag...720&fit=bounds
Need to try some different seating depths to see if I can tighten it up with the 168s
Nice, what powder are you using Greg?
RL26Quote:
Originally Posted by outdoorlad
Shot some some groups with the factory ammo
https://hosting.photobucket.com/imag...720&fit=bounds
Velocity wasn't down much from the box & accuracy was better than I thought it would be :)
Those velocities are pretty good from a 22” barrel!Quote:
Originally Posted by Kiwi Greg
Purchased the 22" 7PRC off Greg a few weeks ago and finally got around to sorting a load for it. Very impressed so far shoots great and minimal fuss to get it grouping well.
Anyone interested in exploring the 7prc road & doing something similar, wouldnt hesistate to give greg a call! :thumbsup:
175gr ELDX, hornady brass. 2950fps with a not too greedy load of RL26 (2225 offered very similar velocity surprisingly) & consistent 1 hole groups. Stoked!
Thanks again greg, happy with the rifle & service. Cheers!
Attachment 225754
Attachment 225755
I had my suspicions 2225 would go well
What primers are you using?
FED215Quote:
Originally Posted by Seventenths
@Kiwi Greg did you end up doing a 20"? How did it perform?
https://www.nzhuntingandshooting.co....a-7-prc-91179/Quote:
Originally Posted by 308mate
Haven't done much with it, had others on the go :)
How does the H2 behave on the 7mm PRC? Did you try different can or only the A-tecQuote:
Originally Posted by 6.5 CRD
Only the h2, havent tried anything else shoots great.Quote:
Originally Posted by tibo
Sent from my iPhone using Tapatalk
