Thread: New lightweight stock

Very nice.
For the grip, there is a technic where you braise together three rounded point nails so their points are at the same level( you might have to cut the heads of two of them) and you gently mark the grip area buy hammering them in your stock. It is the style of finish of a lots of target rifles handles.

What an awesome thread. As I was looking through I saw your mistake with the comb height on the redesign and thought "Its too high, the bolt will foul". an idea for grip though lay out a pattern and use a ball end on you dremel to make round divots, you won't have to cut in far. Glad you went with Talley one piece rings rather than a rail. I'm guessing that's where you ended up with the high comb height.

Great stuff, well done.