6x47
Member

1366 Likes

Page 55 of 92 First ... 54142434445464748495051525354555657585960616263646566676869 ... Last

• Jump to page:

1. 
   Ned liked post by 6x47 On thread : STAGS SHOT 2021

   Scored this fella at daybreak yesterday, was 5mins late heading back into cover.. Crying shame one of his brow tines was broken off https://i.vgy.me/KKmdZL.jpg

   Liked On: 07-04-2021, 08:35 AM

2. 
   Pongo12 liked post by 6x47 On thread : STAGS SHOT 2021

   Scored this fella at daybreak yesterday, was 5mins late heading back into cover.. Crying shame one of his brow tines was broken off https://i.vgy.me/KKmdZL.jpg

   Liked On: 07-04-2021, 08:09 AM

3. 
   CATLINS HUNTER liked post by 6x47 On thread : STAGS SHOT 2021

   Scored this fella at daybreak yesterday, was 5mins late heading back into cover.. Crying shame one of his brow tines was broken off https://i.vgy.me/KKmdZL.jpg

   Liked On: 07-04-2021, 06:11 AM

4. 
   Joe_90 liked post by 6x47 On thread : STAGS SHOT 2021

   Scored this fella at daybreak yesterday, was 5mins late heading back into cover.. Crying shame one of his brow tines was broken off https://i.vgy.me/KKmdZL.jpg

   Liked On: 06-04-2021, 11:45 PM

5. 
   GWH liked post by 6x47 On thread : Varmint options, Your best picks

   One option in a .20 cal is the 20 Practical- just run a .223 case through the die and you're good to go. A small margin under .204 power but that round would fill any hole between the Hornet and the...

   Liked On: 22-03-2021, 01:17 PM

6. 
   Noswal liked post by 6x47 On thread : Varmint options, Your best picks

   One option in a .20 cal is the 20 Practical- just run a .223 case through the die and you're good to go. A small margin under .204 power but that round would fill any hole between the Hornet and the...

   Liked On: 22-03-2021, 12:57 PM

7. 
   Noswal liked post by 6x47 On thread : Varmint options, Your best picks

   If you're trying to hit rabbits for example at 600yds, the .223 is not the answer even with heavies in a fast twist. Wind is the enemy. The 6x47L shooting say 90+ grainers would be in the ballpark....

   Liked On: 19-03-2021, 07:52 PM

8. 
   widerange liked post by 6x47 On thread : 5/16 tap

   It's become a std procedure- soon as I've got a fired case out of a new rifle/barrel, I make a modified case with it. Will give a far more valid reading than any SAAMI-based one.

   Liked On: 18-03-2021, 08:30 AM

9. 
   Rangireice liked post by 6x47 On thread : 7mm08 as a bushpig/bush style rifle

   A 7-08 is -fully- up to the job even with a 16"bbl. CFE223 will easily get you 2900fps + with a 120 TTSX and that is death to anything under 350yds, long as you do your bit.

   Liked On: 10-03-2021, 08:28 PM

10. 
    Moa Hunter liked post by 6x47 On thread : Had to be done

    You're 100% right in bringing it to the attention of forum. Muppets like that give all hunters a bad name.

    Liked On: 04-03-2021, 08:02 AM

11. 
    zimmer liked post by 6x47 On thread : Fixing Run-out

    It's too easy to blame runout for the so-so accuracy. As has been said, the projectile/load/powder just may not be the right one. As for reducing runout, the simplest way is probably to use a std...

    Liked On: 01-03-2021, 09:40 AM

12. 
    Noswal liked post by 6x47 On thread : 22 250 Face lift

    Well assuming the (factory FL) die has pulled the neck diameter down noticeably, the only explanation at this point is an unusually thin neck thickness

    Liked On: 16-02-2021, 01:04 PM

13. 
    Bill999 liked post by 6x47 On thread : 1-8 power scopes

    I suggest you consider a 2.5-8 VX3 for the bush gun. My long range gun wears that Z5

    Liked On: 14-02-2021, 10:49 AM

14. 
    Nathanfish liked post by 6x47 On thread : 1-8 power scopes

    I suggest you consider a 2.5-8 VX3 for the bush gun. My long range gun wears that Z5

    Liked On: 14-02-2021, 07:46 AM

15. 
    canross liked post by 6x47 On thread : Digital Scales - What's a good higher end option?

    It's not the power supply that causes drifting- it's simply that they're strain gauge-based. As has been said, you need to go with a mag restoration force system to keep things stable. I -never- have...

    Liked On: 11-02-2021, 01:53 PM

Page 55 of 92 First ... 54142434445464748495051525354555657585960616263646566676869 ... Last

• Jump to page: