About 7RMBoy

Basic Information


Date of Birth
September 23, 1999 (25)
About 7RMBoy
Biography:
Browning Hell’s Canyon 7mm Rem Mag / Howa 1500 7mm-08
Location:
Nelson
Interests:
Hunting and shooting
Occupation:
Industrial Electrician

Statistics


Total Posts
Total Posts
64
Posts Per Day
0.04
General Information
Last Activity
07-05-2025 08:15 PM
Join Date
30-08-2020
Referrals
0

75 Likes

Page 5 of 5 FirstFirst 12345
  1. 7RMBoy
    7RMBoy liked post by grandpamac On thread : Calculating pressures in hand loads
    Greetings Again 7RMBoy, Yes seating the projectile closer to the rifling does increase pressures and velocity slightly. The greatest effect is with cartridges like the Weatherby magnums that usually...
    Liked On: 24-09-2020, 05:56 PM
  2. 7RMBoy
    7RMBoy liked post by grandpamac On thread : Calculating pressures in hand loads
    Greetings 7RMBoy, Congratulations, you have asked one of those questions to which there are many answers. In short there are ways to estimate pressures but not to calculate them. Most manuals these...
    Liked On: 24-09-2020, 03:32 PM
  3. 7RMBoy
    7RMBoy liked post by winaa On thread : Calculating pressures in hand loads
    Pressures in reloading manual are not calculated they are measured using specialist equipment, and they are really only relevant in the barrel/chamber they were fired in. There are programs that can...
    Liked On: 24-09-2020, 01:45 PM
  4. 7RMBoy
    7RMBoy liked post by r87mm On thread : Ranges in Nelson
    Gourmet Rd is Mot pistol club and like has been said about 400yrds is the limit there( I did try to make it longer but got stopped when i tidied the range up a few years ago) A good range and nice...
    Liked On: 17-09-2020, 05:16 AM
  5. 7RMBoy
    7RMBoy liked post by Pengy On thread : Ranges in Nelson
    No need to apologise. I am old and easily confused :thumbsup:
    Liked On: 15-09-2020, 08:21 PM
  6. 7RMBoy
    7RMBoy liked post by Pengy On thread : Ranges in Nelson
    Bit confused by the request after receiving that pm reply. You asked for ranges in Nelson, but then tell me that Hira is too far out and that you are nearer the lakes. Not having a pop, just a tad...
    Liked On: 15-09-2020, 08:12 PM
  7. 7RMBoy
    7RMBoy liked post by sneeze On thread : Ranges in Nelson
    Dovedale is most likely the Motueka Pistol club. You need to be a member or guest of one to get access.
    Liked On: 14-09-2020, 10:10 PM
  8. 7RMBoy
    7RMBoy liked post by Ftx325 On thread : Ranges in Nelson
    Hi 7RMBoy.... I go out to the cable bay range. Shooting adventures I think they call themselves. Public can use the range on Sundays but you have to call and book a slot, $10 for what is usually an...
    Liked On: 14-09-2020, 10:10 PM
  9. 7RMBoy
    7RMBoy liked post by Shearer On thread : Ranges in Nelson
    Mot pistol club is a good venue. Associate membership for a year is pretty cheap and you can shoot out to 440yards (from memory). Good people to deal with too.
    Liked On: 14-09-2020, 10:09 PM
  10. 7RMBoy
    7RMBoy liked post by zimmer On thread : Dented cases when sizing
    For full length sizing I use the oiled stamp pad method and inevitably lube gets on the shoulder. I don't stress by getting an itty bitty cloth and wiping if off. The cases are only finely filmed,...
    Liked On: 11-09-2020, 08:34 PM
  11. 7RMBoy
    7RMBoy liked post by Micky Duck On thread : Dented cases when sizing
    I use vasoline on fingers..twirl case between them with other hand leaving small film on body of case...the neck is dipped in powdered graphite with steel shot added to it to make it move around...
    Liked On: 11-09-2020, 08:34 PM
  12. 7RMBoy
    7RMBoy liked post by Padox On thread : Dented cases when sizing
    I use graphite power and steel shot 2 md works a treat for inside of the necks
    Liked On: 11-09-2020, 08:34 PM
  13. 7RMBoy
    7RMBoy liked post by Micky Duck On thread : Dented cases when sizing
    pretty sure I saw the wee container of graphite powder in the warehouse of all places...Ive had a wee container for 25 years and havent looked like running out yet.
    Liked On: 11-09-2020, 08:34 PM
  14. 7RMBoy
    7RMBoy liked post by stagstalker On thread : 7mm Rem Mag Browning X-Bolt Hell’s Canyon Reload Advice
    IMR4831 worked very well in my Tikka 7mm Rem Mag with the 162 ELD-X at 20thou jump.
    Liked On: 02-09-2020, 08:12 AM
  15. 7RMBoy
    7RMBoy liked post by Moa Hunter On thread : Terminal effects of bullets explained properly
    . This is a subject we are all interested in. Some very interesting 'not seen before info' here that explains some of those runners...
    Liked On: 01-09-2020, 01:15 PM
Page 5 of 5 FirstFirst 12345

11-06-2021


29-09-2020


14-09-2020


No results to display...
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!