Archie
Member

26 Likes

Page 1 of 2 12 Last

• Jump to page:

1. 
   Archie liked post by buzzmann On thread : Your go to rifle

   The sako I own that week[emoji23] Sent from my iPhone using Tapatalk

   Liked On: Yesterday, 06:57 PM

2. 
   Archie liked post by Micky Duck On thread : Drone

   Not sure it will roast well .but on other side, it's definitely well stuffed.

   Liked On: 06-05-2025, 08:12 PM

3. 
   Archie liked post by Skinny White Boy On thread : Decoys out night before or morning of?

   I do mine opening morning, takes 10-15mins in waders and no dew on them

   Liked On: 02-05-2025, 10:46 PM

4. 
   Archie liked post by csmiffy On thread : Decoys out night before or morning of?

   If possible put them out night before. You say about scaring any off well that's the same thing if you do it in the morning. I know which way I would like it to go. Plus if the area is good and...

   Liked On: 01-05-2025, 09:37 PM

5. 
   Archie liked post by Quackers On thread : Decoys out night before or morning of?

   We do night before far to hard for us to do early moring. We just get thr splasher ducks amd wing spinners going in the morning

   Liked On: 01-05-2025, 08:58 PM

6. 
   Archie liked post by johnd On thread : Help please: 2 3/4” vs 3” 0/U for ducks?

   I used to joke to Browning owners that they were the rejects from the Miroku preselection. I have a 7000 20G and used to have the 9000 in 12G, highly underated in my biased opinion.

   Liked On: 31-03-2025, 08:51 PM

7. 
   Archie liked post by gsp follower On thread : Help please: 2 3/4” vs 3” 0/U for ducks?

   jesus you know your getting old when mirokus considered a old gun waawaa i bought a churchill 612 pump seems nice enough apart from the piss poor reciol pad and factory plug. which aint as easy as...

   Liked On: 30-03-2025, 09:05 PM

8. 
   Archie liked post by Josan On thread : Help please: 2 3/4” vs 3” 0/U for ducks?

   Until recently on the European Browning site there was this text: "All hunting or sporting shotguns (over-and-under or semi-auto guns) by Browning, Winchester and Miroku fitted with the original...

   Liked On: 30-03-2025, 09:05 PM

9. 
   Archie liked post by Rock river arms hunter On thread : Help please: 2 3/4” vs 3” 0/U for ducks?

   Gamebore super steel 2 3/4" 32gr is a great load, Rio blue steel is another great one in 2 3/4". In terms of shot sizes, some prefer 3s, some 4s. I'm in the 4s camp personally but that's because...

   Liked On: 11-02-2025, 09:04 PM

10. 
    Archie liked post by Tahr On thread : Useing the firearms register

    Have been putting registration off. Bit the bullet today. Did it through the phone. 8 rifles. Took 5 minutes. Completely hassle free and great service. The end of the world has been greatly...

    Liked On: 11-02-2025, 03:54 PM

11. 
    Archie liked post by MB On thread : Help please: 2 3/4” vs 3” 0/U for ducks?

    As is choke terminology.

    Liked On: 31-01-2025, 08:21 PM

12. 
    Archie liked post by Quackers On thread : Help please: 2 3/4” vs 3” 0/U for ducks?

    Just remember UK and USA shot size is different aswell .

    Liked On: 31-01-2025, 08:21 PM

13. 
    Archie liked post by Micky Duck On thread : Help please: 2 3/4” vs 3” 0/U for ducks?

    Fitting new butplate is easy enough.a slip on one works too.

    Liked On: 31-01-2025, 08:21 PM

14. 
    Archie liked post by Micky Duck On thread : Help please: 2 3/4” vs 3” 0/U for ducks?

    Size #3 is largest recommend for tight chokes and by keeping payload down to 34grm or lighter you can use larger shot sizes...it's like a whole lot of people barreling down wide corridor heading forr...

    Liked On: 31-01-2025, 08:21 PM

15. 
    Archie liked post by kotuku On thread : Help please: 2 3/4” vs 3” 0/U for ducks?

    Get a 3"chambering then you can use both. GSPFs mentioned Baikal O/U is in fact mine,a sweet wee single trigger model. Which is my go to gun for feral geese lost count of the number ive bowled...

    Liked On: 31-01-2025, 08:21 PM

Page 1 of 2 12 Last

• Jump to page: