I was 77gr of 2217 with the 200gr eld getting 2900fps with a 26inch barrel.
Liked On: 11-06-2020, 07:23 PM
As requested. 142228
Liked On: 11-06-2020, 07:22 AM
Quite a mild 75.5gn of ADI 2217. As I've gone for accuracy and brass life over stonking velocity. Using PPU (Privi/Highland) brass and CCI Magnum primers.
Liked On: 10-06-2020, 06:52 PM
What I've done for the 300WM loads for a Sako A7, is to have 180gn SSTs to fit the mag for general hunting within 300-350m. As the A7 has a stupidly short magazine. Even factory 180gn soft points are...
Liked On: 10-06-2020, 03:08 PM
I drilled out my Hornady 6.5CM seating stem with a 3.5mm drill bit in a cordless drill. 143gr ELD-X no longer had their tips flattened. Easy. I know i could have bought another stem for ELDs, but i...
Liked On: 25-04-2020, 05:56 PM
looks to me like it may be the wrong seating stem. Rather than the bullets touching the end,they are just not fitting inside the seater. So either turn it out or check that you have the correct...
Liked On: 25-04-2020, 06:40 AM
If you have access to a lathe it is easy enough to just make some new ones. I found with the Lee dies you might have to make the stem longer to get them to work nicely with the design I made. I...
Liked On: 25-04-2020, 06:40 AM