Brian Litz has an article somewhere on this - basic gist was it is impossible physics for a bullet to settle down and get more accurate at range e.g be 2 moa at 100 yards and then 0.5 at 600
Liked On: 26-05-2021, 02:03 PM
Nice rig Country Cuts Practise to achieve first round hits in the kill zone for every shot you take Take a small note pad with you and note down the factors present for each shot and it’s...
Liked On: 26-05-2021, 02:02 PM
Just head shoot the c**ts :thumbsup:
Liked On: 26-05-2021, 01:57 PM
Not sure about Nathan he certainly has done a lot of work however his total objection to the use of a bipod pretty much turned me right off his ideas. If you want to shoot off a pack go for it but...
Liked On: 26-05-2021, 01:56 PM
well LOOKING at what you have sectioned...the SMK has lighter jacket so if opening in tip is same as the SGK it would open up FASTER....by making the metal in front bit softer than rear IT COULD slow...
Liked On: 26-05-2021, 01:54 PM
Nathan's a good cunt
Liked On: 26-05-2021, 01:52 PM
It’s a real shame that Foster went with this bullet annealing business as it has totally polluted the rest of his work, the world over. Google it, comes up in forums from every corner of the planet...
Liked On: 26-05-2021, 01:52 PM
Hi all I have a 30-06 Parker Hale and bought some new unfixed Hornady brass, have had to full length resize the lot, bolt won’t go within 5 mm of starting to close. Normally with new brass I have...
Liked On: 16-05-2020, 01:47 AM
https://concen.org/content/complete-gunsmithing-library Check this out-put it in the firearms section but then realised it probably should be here. Bits and pieces missing but usually noted as...
Liked On: 14-05-2020, 09:06 PM
If you get sick of the speed arms race you can always try for accuracy I suppose... Remington 700 with 25" Criterion std twist barrel and ASE suppressor on the front. 208 ELD-M Norma brass,...
Liked On: 26-04-2020, 01:39 AM
ELD-M 208s in my 26” .300 Win Mag do 2980 with 2217 (H1000). It's probably the go to powder for this cartridge and is very temp stable too.
Liked On: 26-04-2020, 01:38 AM