Micky Duck It always amuses me a bit when there's a post about disappointing velocity along with " I've had the barrel cut down to xx" Doing this with a cartridge optimized for a 22 or longer barrel...
Liked On: 16-11-2022, 09:12 AM
1969/70 I was the senior firearms salesman at Tisdalls in Ch-Ch and we were selling unissued Long Branch No4 .303's for $29.95, and I purchased a very tidy SMLE No1 Mk1 from Cromb & Merrits (over the...
Liked On: 16-11-2022, 09:10 AM
I've got plenty of front sight blades of varying heights. Flick me a pm.
Liked On: 15-11-2022, 08:58 PM
Bit more info for you , serial numbers date the rifle 1924/25 , not certain it is a Type B now , it is unusual to have that large Mauser banner on the front receiver ring like that , the 7 x 57...
Liked On: 15-11-2022, 07:16 PM
kotuku, I've got a stirling 14p with no magazine you can have if you want? Just need to get from Central up to Chch.
Liked On: 15-11-2022, 05:55 PM
In 1978 I sold a fairly flashy pony that I'd bred and broken in (all with Dads help) for I think the unprecedented sum of $600. As soon as I went back to boarding school I promptly matched off to...
Liked On: 15-11-2022, 05:47 PM
Sucky hole flap? I was following you right up until you got to that point and then my mind has gone off on a bit of a tangent I think haha
Liked On: 15-11-2022, 09:20 AM
https://www.trademe.co.nz/motors/used-cars/toyota/auction-3836665605.htm Bit older but would be a primo Ute.
Liked On: 14-11-2022, 05:13 PM
Ok, sounds like a lot of interest in these dies. I'm not opposed to doing a run of these. However they are quite a bit of work, so likely to not be cheap, but likely less than it would cost to import...
Liked On: 14-11-2022, 05:12 PM
I have noticed that certain brands are definitely much harder lead. For example, CCI std is extremely hard and does not take a hollow point that well. SK match is the softest I have found so far.
Liked On: 14-11-2022, 05:09 PM
both I believe....
Liked On: 13-11-2022, 09:47 PM
87 Sp no: 2440 listed as varmint and medium game in vol 4 Hornady manual, Is a flat base spitzer.
Liked On: 13-11-2022, 08:34 PM
I have a marshmallow cannon I made for kids parties. It's literally a section of 40mm pvc with a t-junction and a plastic flap on one end. The power comes from the vacuum cleaner in the t-junction...
Liked On: 13-11-2022, 05:44 PM
Other things for these, the manuals pre '92 are ugly on reverse syncro keys and def do not like being run on ATF like the post '92 manual trans are specc'd for. My SWB dumped the reverse syncro keys...
Liked On: 13-11-2022, 12:16 PM
Good luck with that. They never produced the A7 in 223.
Liked On: 13-11-2022, 12:14 PM