I used this process with the kids "helping" couple of years ago. Rough enough was good enough. Worked well. Smashed out 50 in a couple of hours ...
Liked On: 11-04-2024, 11:08 AM
I bought one from an outdoors shop in the main street of Hamilton in 1997. I think the shop is long gone but can take some pictures if you want. If I were doing it now I would just get one from...
Liked On: 14-02-2024, 06:17 AM
I bought one from an outdoors shop in the main street of Hamilton in 1997. I think the shop is long gone but can take some pictures if you want. If I were doing it now I would just get one from...
Liked On: 13-02-2024, 01:34 PM
No problems. Wasn't even couriered. Just ordinary post. Only went that way as mcarbo don't seem to ship to nz
Liked On: 17-11-2023, 11:02 AM
I also bought a gunbloke spring (have an mcarbo spring in another xbolt). Haven't measured oull but feels good, possibly lighter than mcarbo . The sear spring was sideways from the factory so I...
Liked On: 17-11-2023, 11:02 AM
I have a 16 gun fire proof job. Wish I had gone bigger. Unless they are all small opensight rifles or single barrel shotguns you can't fit anywhere near that number of firearms in there, let alone...
Liked On: 10-11-2023, 05:22 PM
If you're careful, try lapping the bolt to the raceways so its as smooth as it can get. Also "smoothing" or putting a gentle radius on the lower rear of the bolt to help it ride over the hammer...
Liked On: 28-08-2023, 10:52 AM
Have you tried without suppressor or with different muzzle device
Liked On: 26-08-2023, 08:53 PM
Have you tried without suppressor or with different muzzle device
Liked On: 26-08-2023, 02:20 PM
If you're careful, try lapping the bolt to the raceways so its as smooth as it can get. Also "smoothing" or putting a gentle radius on the lower rear of the bolt to help it ride over the hammer...
Liked On: 22-08-2023, 08:50 AM
If you're careful, try lapping the bolt to the raceways so its as smooth as it can get. Also "smoothing" or putting a gentle radius on the lower rear of the bolt to help it ride over the hammer...
Liked On: 21-08-2023, 03:21 PM
Possibly either torque on the stock (while trying to aim in an awkward position) twisting the action or causing the stock contact he barrel, or parallax issues fromm awkward positioning, I.e. not...
Liked On: 08-08-2023, 07:18 PM
Osange orange if you can find it. Otherwise try find some old skis,use front half and shape them for limbs. Laminate some wood and something synthetic for a handle and bolt ski bits to it.
Liked On: 08-06-2023, 03:42 PM
Osange orange if you can find it. Otherwise try find some old skis,use front half and shape them for limbs. Laminate some wood and something synthetic for a handle and bolt ski bits to it.
Liked On: 07-06-2023, 06:27 PM
Should be drop for 260 but windage for 300
Liked On: 04-04-2023, 05:57 PM