Soldering iron tip held on the top of the screw head just long enough to heat the length of the screw can loosen the glue/loctite.... good luck
Liked On: 30-10-2019, 09:12 PM
I might be able to take you for a chamois depending on exact dates?
Liked On: 28-10-2019, 01:52 PM
Many of the most accurate shooters will full-length size with a shoulder bump of only about 2thou. This achieves the benefits of neck sizing only, in that the brass fits the chamber pretty much...
Liked On: 14-10-2019, 06:50 PM
121957 Inov8 mountain running "shoes". Super light . Even walked out of the Waipakahi in them one time with a full pack just to see if I could.
Liked On: 12-10-2019, 08:08 PM
The rear base holes are clearly misaligned. A reputable firm would correct the problem at no charge even if they did not do the job originally. It is not a big or expensive job to repair but does...
Liked On: 11-10-2019, 10:04 PM
My guess is the primers are a little low, the shoulder/headspace a little short & the primers a little hard, added together = misfires... Fed 205s maybe your friend in this instance, typically the...
Liked On: 11-10-2019, 06:43 PM
I dont think it would have a recoil lug or much in the way of bedding if its what i think it is
Liked On: 10-10-2019, 11:52 AM
Pew-Pew. Yes. Sorry mate; I didnt realise it was near Mokau till I just checked a map. Cripes, would love to be there but over 220km from home. Love the concept and I wish the organisers every...
Liked On: 09-10-2019, 08:16 PM
Thanks man. I'm using a sony rx10, good camera so far.
Liked On: 09-10-2019, 04:38 PM
Also a good series on youtube. Go to "AirarmsguntingSA" watch playlist "Oxwagon diaries" and "Vapour Trails" Some long range hunting in there and beautiful landscapes Sent from my SM-G960F...
Liked On: 08-10-2019, 11:50 PM
Vudoo-ism. I just want to poke holes in a doll with it... Happy 121683 Birthday 121684 To 121685 Me. Thanks Kiwi Greg
Liked On: 08-10-2019, 08:02 PM
Lone Peak Fuzion 7mm Blaser Magnum Built by Dean Maisey, This rifle has been together for a few months now and the owner is very happy with it and has sent me these pics from his load development...
Liked On: 06-10-2019, 03:34 PM
My 2 cents worth as I went down this track couple years ago , ended up with 308 with 20 inch barrel and DPT , I have a small 10 power nightforce scope for reliable dial up , obviously the 308 has its...
Liked On: 05-10-2019, 01:53 PM
Made a striker disc tool and finally got the stuck disc out of my AYA shotgun double rifle donor 121189
Liked On: 02-10-2019, 07:57 AM
I agree with Jaco - just get the permit. Simple to complete, and it saves a lot pain down the line. There was a detailed discussion a while ago - what Police says, what Customs says and what the...
Liked On: 01-10-2019, 06:06 AM