Flyblown Gibo rather than retype the info can you have a look in the events section for me thanks. Sideshow of course your sister can come along instead of you....... please send picture of rifle...
Liked On: 25-01-2019, 08:52 AM
The best tip I can give you, if you buy a progressive press is to spend some extra bucks and buy a heap of primer tubes. If money was less of an issue than time I would opt for a 1050. If you are...
Liked On: 24-01-2019, 07:06 PM
Kurt Try BRT in Aussie they are pretty good on Wilson gear
Liked On: 24-01-2019, 11:41 AM
The best tip I can give you, if you buy a progressive press is to spend some extra bucks and buy a heap of primer tubes. If money was less of an issue than time I would opt for a 1050. If you are...
Liked On: 23-01-2019, 08:59 AM
If your stock already has checkering why not mask the area and get into it with some stripper and a tooth brush, comes up mint and no risk of an over run / slip with a checkering tool.
Liked On: 21-01-2019, 10:14 PM
Tommy even when its not the FS section you gotta be quick for a bargain. Sorry the 10 large sticks are gone SPF. But I still have the small ones. $7.50 ea to you mate.
Liked On: 21-01-2019, 06:21 PM
So after Kurt started this post I dug out my supply of solder sticks, but as he now has a supply these are on offer. I have 10 sticks that are 500 grams each and a couple of the smaller panel...
Liked On: 21-01-2019, 06:09 PM
A VLD stem may help but you arent bottoming out on the projectile tip anyways. But a VLD may give less of an angle onto the orgive.
Liked On: 21-01-2019, 06:07 PM
If your stock already has checkering why not mask the area and get into it with some stripper and a tooth brush, comes up mint and no risk of an over run / slip with a checkering tool.
Liked On: 21-01-2019, 05:18 PM
The best tip I can give you, if you buy a progressive press is to spend some extra bucks and buy a heap of primer tubes. If money was less of an issue than time I would opt for a 1050. If you are...
Liked On: 21-01-2019, 10:36 AM
The best tip I can give you, if you buy a progressive press is to spend some extra bucks and buy a heap of primer tubes. If money was less of an issue than time I would opt for a 1050. If you are...
Liked On: 20-01-2019, 10:50 PM
The best tip I can give you, if you buy a progressive press is to spend some extra bucks and buy a heap of primer tubes. If money was less of an issue than time I would opt for a 1050. If you are...
Liked On: 20-01-2019, 08:29 PM
If you dont already have some tools such as: large and small primer pocket cleaner Large and small primer pocket reamer inside neck chamfer outside neck chamfer Then i would look at getting...
Liked On: 14-01-2019, 08:16 PM
If you dont already have some tools such as: large and small primer pocket cleaner Large and small primer pocket reamer inside neck chamfer outside neck chamfer Then i would look at getting...
Liked On: 14-01-2019, 06:36 PM
Press arrived in about a week. Feels a sturdy wee O frame made of cast steel. Could do with some finishing work to the paint work and a few burrs here and there. There is some play in the ram...
Liked On: 13-01-2019, 10:35 PM